Updating Firmware - Bogen NQ-EDP01 Configuration Manual

Firmware Version
Standalone Operation
The following buttons are available at the top of all pages in the application.
Dashboard
Configuration Settings
Network Settings
Firmware Update
Logs
DSP
Help
Manual
Logout

Updating Firmware

When you select Firmware Update
page appears. From this page you can determine which Nyquist firmware version the
appliance is using and if an update is available. You can also load a firmware release,
install the loaded firmware, restore the configuration to factory defaults, and reboot the
appliance.
Table 1. Appliance Dashboard Fields
Provides the firmware version installed on the station.
Enables or disables Standalone mode.
Table 2. Appliance Dashboard Buttons
Displays the dashboard.
Accesses the Configuration Settings page where you can
view various options or select to receive configuration
settings from the server.
Accesses the Network Settings page where you can view
and set network settings, such as the static IP address.
Accesses the Firmware Update page where you can view
the current Nyquist version, update firmware to a new
version, the configuration to factory defaults, and
reboot the appliance.
Accesses log files, which record either events or mes-
sages that occur when software runs and are used when
troubleshooting the appliance.
Accesses the DSP page where you can view and set
parameters for Digital Signal Processing (DSP).
Accesses the appliance's online help.
Displays the appliance's configuration manual.
Logs out of the appliance's dashboard.
from the appliance's web UI, the Firmware Update
3