Table Of Contents; Safety Information - Husky K40365 Use And Care Manual

1200 lumen led corded handheld work light

Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Read and understand all Safety and Operating instructions in this

manual before using this product.

DANGER: BE EXTREMELY CAREFUL WHEN USING THIS

DEVICE. Improper use of this worklight can result in injury

or death.

WARNING: Failure to observe the following safety rules

may result in FIRE, ELECTRICAL SHOCK, OR INJURY.

Voltage: 120V AC; Frequency: 60Hz; Current: 0.13A

SAVE THESE INSTRUCTIONS.

Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

FCC STATEMENT

WARNING:

expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

NOTICE: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Table of Contents