Table of Contents
Advertisement
Model No.:
36414TCB3CD – 10 gal (38 liter) Extractor
Manufactured by Kleenrite
CAUTION: Read the instruction manual
before using the appliance.
KLEENRITE
1122 MAPLE STREET
MADERA CA 93637 U.S.A.
FAX: 1-559-673-5725
CUSTOMER SERVICE: 1-800-241-4865
Powerbase 10
CARPET AND UPHOLSTERY CLEANER
Operator and Parts Manual
MNL36414TCB3CD
Rev. 00 (5-17)
Advertisement
Table of Contents
Summary of Contents for ChemDry Powerbase 10
- Page 1 Powerbase 10 CARPET AND UPHOLSTERY CLEANER Operator and Parts Manual Model No.: 36414TCB3CD – 10 gal (38 liter) Extractor Manufactured by Kleenrite CAUTION: Read the instruction manual before using the appliance. KLEENRITE 1122 MAPLE STREET MADERA CA 93637 U.S.A. FAX: 1-559-673-5725...
- Page 2 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions must always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE. This machine is for commercial use. To reduce the risk of fire, electric shock, or injury: WARNING: Do not operate machine unless trained and authorized.
- Page 3 CONSIGNES DE SECURITE IMPORTANTES L’utilisation d’un appareil électrique demande certaines précautions: LIRE TOUTES LES INSTRUCTIONS AVANT D'UTILISER CETTE MACHINE. Cette machine est pour un usage commercial. Pour réduire le risque d'incendie, d'électrocution AVERTISSIMENT: ou de blessures : N'utilisez pas la machine à moins formés et habilités. Se connecter à...
-
Page 4: Table Of Contents
OPERATION This manual is furnished with each new model. It MACHINE DATA provides necessary operation and maintenance instructions and an illustrated parts list. Please fill out at time of installation for future reference. Read this manual completely and understand the machine before operating or servicing it. -
Page 5: Safety Precautions
OPERATION – Use manufacturer supplied or approved SAFETY PRECAUTIONS replacement parts. – Have service performed by authorized service person. This machine is intended for commercial use. It is designed to wet clean carpet and upholstery in a WARNING: Hazardous Voltage. Shock or indoor environment and is not constructed for any electrocution can result. -
Page 6: Machine Components
OPERATION MACHINE COMPONENTS 1. Recovery Tank 10. Heater On Indicator 2. Solution Tank 11. Auxiliary Heater Switch 3. Vacuum Hose Connector 12. Vacuum Switch 4. Solution Tank Lid 13. Pump Switch 5. Solution Hose Connector 14. Recovery Tank Drain Handle 6. -
Page 7: Machine Operation
OPERATION ATTENTION: Thoroughly dissolve and mix cleaning solutions prior to pouring into machine. 4. Plug machine’s power cord into grounded wall outlet on separate circuits. 5. If using two cords, lock both front wheels (Figure 3). This is necessary to comply with international electrical safety directives. -
Page 8: Draining Tanks
OPERATION 2. Operate accessory tool as normal (Figure 8). 2. Place empty-out nozzle over a bucket and turn on pump until all the solution has been pumped from solution tank (Figure 10). Fig. 8 Fig. 10 3. Replace empty-out nozzle to its storage location. NOTE: Before cleaning upholstery, always check cleaning instructions sewn in furniture by FREEZE PROTECTION... - Page 9 ADJUSTING PUMP PRESSURE 1. The pump in the PowerBase 10 is an on-demand pump. The advantage to having this type of pump is that it is working (pumping) only when solution is required.Adjusting pump pressure...
-
Page 10: Storing Machine
OPERATION 5. Lubricate female hose couplers with lightweight MACHINE MAINTENANCE (SCHEDULED) oil. MONTHLY MAINTENANCE To keep machine in good working condition, simply (Every 80 Hours of Operation) follow machine’s daily, weekly and monthly 1. Lubricate wheels with water resistant oil. maintenance procedures. -
Page 11: Trouble Shooting
OPERATION TROUBLE SHOOTING PROBLEM CAUSE SOLUTION Machine does not operate. Faulty switches or wiring. Contact Service Center. Faulty power cord. Contact Service Center. Building circuit breaker tripped. Reset Breaker. Heater does not heat. Faulty switch or wiring. Contact service center. Solution pump does not operate. -
Page 12: Specifications
OPERATION SPECIFICATIONS Model 36414TCB3CD LENGTH 711 mm (28 in) WIDTH 450 mm (17.7 in) HEIGHT 1016 mm (40 in) WEIGHT 54.9 Kg (121lbs) SOLUTION TANK CAPACITY 41 L (11 gal) RECOVERY TANK CAPACITY 38L (10 gal) SOLUTION PUMP 220 V, 6.8 bar (100psi), .4 A VACUUM MOTOR 220 V, 6A, 1380W;... -
Page 13: Electrical Diagram
ELECTRICAL DIAGRAM 36414TCB3CD 240 V WIRING DIAGRAM 36414TCB3CD (5-17) - Page 14 ELECTRICAL DIAGRAM 36414TCB3CD 240 V WIRING DIAGRAM 36414TCB3CD (5-17)
-
Page 15: Parts List
PARTS LIST 36414TCB3CD TANK GROUP 36414TCB3CD (5-17) - Page 16 PARTS LIST 36414TCB3CD TANK GROUP Part # Description Part # Description B-21 10-32 X 5/16 PHXSS K-13.3 LIGHT, RED ROUND B-23 10-32 X 1/2 PHXSS K-16.85A NUT, NYLON BELL MOUTH 13-10MM B-24 10-32 X 3/4 PHXSS K-21WGRY SWITCH,SPST WTR RESIS GRY B-26.7 10-32 X 1 1/2 PHXZINC K-28.05...
- Page 17 PARTS LIST 36414TCB3CD BASE GROUP 36414TCB3CD (5-17)
- Page 18 PARTS LIST 36414TCB3CD BASE GROUP Part # Description Part # Description B-10 6-32 X 1/2 PHXSS F-11SS Q/C 1/4 SOC SS SHUT OFF B-10.1 # 6 X 1/4 SELF TAPPING G-03.15 O-RING,VITON -4 OR FIT90D B-14 NUT 6-32 HEX SS J-02.7 CAST ALUM COIL NEX GEN B-17.6...
- Page 19 PARTS LIST 36414TCB3CD HANDLE GROUP 36414TCB3CD (5-17)
- Page 20 PARTS LIST 36414TCB3CD HANDLE GROUP Part # Description Part # Description B-21 10-32 X 5/16 PHXSS K-13.3 LIGHT, RED ROUND B-23 10-32 X 1/2 PHXSS K-16.85A NUT, NYLON BELL MOUTH 13-10MM B-24 10-32 X 3/4 PHXSS K-21WGRY SWITCH,SPST WTR RESIS GRY B-26.7 10-32 X 1 1/2 PHXZINC K-28.05...
-
Page 21: Warranty Policy
POWERBASE 10 WARRANTY POLICY LABOR & PARTS POLICY For the first 12 months from the date of original purchase, upon Kleenrite’s determination, product manufacturing defects will be repaired or replaced at no charge for labor and/or parts provided that the machine or part(s) is delivered or shipped freight prepaid to Kleenrite or its designated repair center and provided that a Return Authorization is obtained from Kleenrite prior to machine or part(s) being shipped. -
Page 22: Warranty
Damage caused by plugged filters and screens is not covered. This warranty shall not cover any Powerbase 10 cleaning machine housing, part or assembly if there is evidence of misuse, alteration, owner neglect, lack of proper maintenance, improper chemical use, improper voltage, abuse, accident, freezing, spillage, dropping, flood, fire, etc. - Page 23 Damage caused by plugged filters and screens is not covered. This warranty shall not cover any Powerbase 10 cleaning machine housing, part or assembly if there is evidence of misuse, alteration, owner neglect, lack of proper maintenance, improper chemical use, improper voltage, abuse, accident, freezing, spillage, dropping, flood, fire, etc.
Need help?
Do you have a question about the Powerbase 10 and is the answer not in the manual?
Questions and answers
the unit is not heating i was wondering where the elements are located so i can test them.
The heating elements in the ChemDry Powerbase 10 unit are associated with the "Main Heater" and "Auxiliary Heater." The components related to testing these elements include:
- Main Heater Switch
- Main Heater On Indicator
- Main Heater Circuit Breaker
- Auxiliary Heater Switch
- Heater On Indicator
- Auxiliary Heater Circuit Breaker
These components are part of the machine and are used to operate and monitor the heating elements. The actual heating elements would be located internally and electrically connected to these switches and indicators.
This answer is automatically generated