ASSEMBLY INSTRUCTIONS
UNITE L2 EXTEND
UNITE XL2 EXTEND
COMPONENTS
End tabletop
Middle tabletop
Plate
Beam
Inner leg
END
MIDDLE
outer leg
outer leg
Foot
Screw
Countersunk
screw
Washer
Bolt
Adjustable
feet M8
Required tools: hex key, crosshead
screwdriver, adjustable spanner.
www.balzar.se
Assemble all the legs, start by putting a
1
foot into an inner leg.
Repeat step 1 till 3 to assemble all the
4
other legs.
UNITE L2 EXTEND
Slide the outer leg over the inner leg.
2
Secure using an adjustable spanner
and 1 x Bolt + 1 x Washer. Tighten the
bolt so there is no movement in the
foot! Much force is needed!
Put a tabletop with rounded corners
5
upside on a protective corner. Make
sure there is a guidance slat and 2
latches.
hook
guidance slat
UNITE XL2 EXTEND
Attach the mounting plate using a hex
3
key and 3 x Countersunk screw. Re-
peat step 1 till 3 for the other 2 legs.
Use the holes in the tabletop to
6
position 2 legs on it. The left leg should
be an END leg, the right leg a MIDDLE
An END leg has 2 holes for 1 beam
A MIDDLE leg has 4 holes for 2