Troubleshooting; Remote Control Does Not Work - Philips 20PFL3403/60 User Manual

Lcd tv with crystal clear iii
Table of Contents

Advertisement

8.

Troubleshooting

Some problems you encounter with your TV
can be corrected by consulting the following
list.
No picture, no sound
1.
Check if the fuse or circuit breaker is
working.
2.
Plug another electrical device into the
outlet to make sure it is working or turned
on.
3.
Power plug is in a bad contact with the
outlet.
4.
Check the signal source.
No colour
1.
Change the colour system.
2.
Adjust the saturation.
3.
Try another program. Black-white program
may be received.

Remote control does not work

1.
Change the batteries.
2.
Batteries are not installed correctly.
3.
Main power is not connected.
No picture, normal sound
1.
Adjust the brightness and contrast.
2.
Broadcasting failure may happen.
Normal picture, no sound
1.
Press the
VOLUME + button to increase
volume.
2.
Volume is set to mute, press
restore sound.
3.
Change the sound system.
4.
Broadcasting failure may happen.
Ripples on the picture
EN-28
Blank screen in VGA(PC) mode
Snowy dots and interference
Ignition
Ghost
MUTE to
Radio frequency interference
Usually caused by local interference such as
cars, daylight lamps
the antenna to minimize the interference.
Perhaps the TV can not recognize the
resolution set by the PC. Change to
the best resolution or other standard
resolutions of the PC system.
Check the connections.
If the antenna is located in the fringe area
of a television signal where the signal is
weak, the picture may be marred by dots.
When the signal is extremely weak, it may
be necessary to install a special antenna to
improve the reception.
Adjust the position and orientation of
the indoor/outdoor antenna.
Check the connection of antenna.
Fine tune the program.
Try another program. Broadcasting
failure may happen.
Black spots or horizontal streaks appear, or
the picture flutters or drifts. This is usually
caused by interference from car ignition
system, neon lamps, electric drills, or other
electrical appliance.
Ghosts are caused by the television signal
following two paths. One is the direct path,
the other is reflected from tall buildings,
hills, or other objects. Changing the
direction or position of the antenna may
improve the reception.
This interference produces moving ripples
or diagonal streaks, and in some case, loss
of contrast in the picture. Find out and
remove
the radio interference source.
and hair driers. Adjust

Advertisement

Table of Contents
loading

This manual is also suitable for:

22pfl3403s/6020pfl3403s/6019pfl3403s/60

Table of Contents