Subscribe to Our Youtube Channel
Summary of Contents for Regulus 19401
- Page 1 Installation Manual Kit for connecting relay module to RegulusBOX Relay module kit...
- Page 2 How to install 4 relays 19401 to RegulusBOX Read the entire instruction manual first. Have the following tools ready: • drill with drill bits 3 and 4 mm, • Phillips screwdriver, • a small flathead screwdriver, • kit for connecting relay module. Disconnect RegulusBOX from electricity. Find the circuit breaker upstream of the BOX and turn it off. Verify that the input terminals are de-energized.
- Page 3 Attach the DIN rail with terminal blocks to the back plate of the RegulusBOX, mark the screw holes. Position the DIN rail as shown. If RegulusBOX already contains pre-drilled holes, just screw the DIN rail with terminal blocks using M4 screws. Proceed to point 8. Drill the holes and screw on the DIN rail with the terminal blocks using self-tapping screws (watch out for metal sawdust).
- Page 4 In the picture, the corresponding holes are marked in white. After inserting the conductor into the terminal, make sure that the conductor is firmly connected to the terminal by pulling on the conductors (white holes in the picture, for inserting the conductors). Insert all wires into the cable duct and cover it. 13. Visually inspect the entire installation and only after that you may start the RegulusBOX. v1.0-02/2022 ©2022 We reserve the right to errors, changes and improvements without prior notice. REGULUS spol. s r.o. E-mail: sales@regulus.eu Web: www.regulus.eu...
Need help?
Do you have a question about the 19401 and is the answer not in the manual?
Questions and answers