Advertisement
Advertisement
Table of Contents
Summary of Contents for FIBERROAD FR-2703
- Page 2 Notes: If you make your own cable, we suggest labeling the two sides of the same line with the same letter (A-to-A and B-to-B, shown as below, or A1-to-A2 and B1-to-B2). © 2022 Fiberroad Technology Co., Ltd All right reserved Page 1 of 5...
- Page 3 X port of Converter and HUB. 10/100/1000Base-TX are used in MDI/MDI-X, the define of Pin in the table as below. MDI Signal MDIX Signal Definition Definition Figure 1 10/100/1000M Lan Port Pinouts © 2022 Fiberroad Technology Co., Ltd All right reserved Page 2 of 5...
- Page 4 PC or other MDI Device Switch, hub or other MDIX Device Crossover cable Straight-through cable MDIX Straight-through cable Crossover cable Auto- Either crossover or straight-through cable MDI/MDIX ❖ Drawing © 2022 Fiberroad Technology Co., Ltd All right reserved Page 3 of 5...
-
Page 5: Installation
(small swerving causes terrible loss of link). Its banding should be moderate, not too tight, and should be separated from other cables; 9. It should have corresponding simple signal at both sides of the cable for maintaining. © 2022 Fiberroad Technology Co., Ltd All right reserved Page 4 of 5... -
Page 6: Specification
-40℃~75℃ (-40 to 167 ℉) Operating Humidity 5%~90% (non-condensing) Storage Temperature -40℃~85℃ (-40 to 185 ℉) Warranty MTBF ＞300,000 hours Defects Liability Period 5 years warranty, lifetime technical support © 2022 Fiberroad Technology Co., Ltd All right reserved Page 5 of 5...
Need help?
Do you have a question about the FR-2703 and is the answer not in the manual?
Questions and answers