Table of Contents
Advertisement
Placing your Cooktop into the Cut Out
1. Stretch out the supplied seal along the underside edge of the cooktop, ensuring the ends overlap
at the corners.
2. Do not use an adhesive to fix the cooktop into the worktop. Once the seal is fitted, position the
cooktop into the cutout in the worktop. Apply gentle downward pressure onto the cooktop to
push it into the worktop, ensuring a good seal around the outer edge.
•
The cooktop must be installed by qualified personnel or technicians. Please never attempt
installation by yourself.
•
The cooktop should not be installed above a dishwasher, fridge, freezer, washing machine, or
clothes dryer, as the humidity may damage the cooktop's electronics.
•
The ceramic cooktop should be installed such that better heat radiation can be ensured to
enhance its reliability.
•
The wall and induced heating zone above the table surface shall withstand heat.
•
To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
Connecting the Cooktop to the Power Supply
•
Improper connection of the equipment-grounding can result in the risk of electrical shock. If the
power cord of the unit is damaged, have it replaced by an authorized service center.
•
This appliance may be connected by mean of permanent "Hard Wiring" or "Power Supply Cord
Kit". A power supply cord is not supplied but is available through your local electrical supply
house.
•
Use only 3-conductor UL listed cord rated at 20 amps with 240V minimum voltage range. These
cords may be provided with strain relief or conduit connector.
•
This unit must be connected to the proper electrical voltage and frequency at specified on the
rating label.
•
The unit should be connected directly to the junction box through fixable, armored, or
nonmetallic sheathed, copper cable. The flexible, armored cable extended from the fuse box or
circuit breaker box should be connected directly to the junction box. Locate the junction box to
allow as much slack as possible between the junction box and the unit so that the unit can be
moved if servicing becomes necessary in the future.
•
DO NOT cut the conduit. Use the length of conduit provided.
•
For personal safety, this appliance must be properly grounded.
•
Remove house fuse or open circuit breaker before beginning installation.
•
DO NOT attempt to repair or replace any part of the appliance unless it is specifically
recommended in this manual. All other servicing should be referred to a qualified technician.
•
To minimize the possibility of electric shock, disconnect this appliance from the A/C power
supply before attempting any maintenance.
8
Advertisement
Table of Contents
