(see fig. F 2). F 2 – Assembly of the belt drive on the pulley and the sub-platter Note: If you start the drive of the PE 1000 by turning it on without having placed the platter, it may happen that the drive belt falls off due to the low weight! Next, put the platter on the sub-platter.
5. Tone arm and pick-up cartridge The PE 1000 is delivered with a preinstalled tone arm Perpetuum Ebner TO 2016, as well as with an installed ORTOFON pickup, model 2M.
To prevent this, the so- called anti-skating force is applied at the tone arm. At the PE 1000, this was realized by a built-in magnet. The anti-skating force is preset at delivery, but it can be ad- justed if necessary, using a set screw below the tone arm bearing block.