kenall Indigo-Clean IC100 Installation Instructions

IC100 CONTROL SYSTEM
When using electrical equipment, basic safety precautions should always be followed, including the following:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED. DISCONNECT POWER TO ALL CIRCUITS
BEFORE WIRING FIXTURE. INSTALL IN ACCORDANCE WITH ALL NATIONAL, STATE, AND LOCAL CODES. DO NOT CONNECT TO
AN UNGROUNDED SUPPLY. READ ALL FIXTURE MARKINGS AND LABELS TO ENSURE CORRECT INSTALLATION OF FIXTURE.
SUPPLEMENTAL INSTRUCTIONS MAY BE LOCATED ON THE FIXTURE, IN ADDITION TO THIS INSTRUCTION SHEET, REGARDING
INSTALLATION INSTRUCTIONS

CONTROLLER BOX INSTALLATION

1. Open housing using supplied key.
2. Determine which side(s) of housing control wires and lead wires will be entering and exiting. Remove knockout(s), install 1/2" NPT
wet location conduit fitting(s), and seal threads using approved method.
3. Place housing at the intended mounting location. Locate and drill (4) pilot holes in mounting surface using housing as template or
see figure 1 below. Using 1/4-20 fasteners and anchors appropriate to the mounting surface (supplied by others), mount housing
to surface.
1.17"
6.85"
4.50"
4. Input rating: 120VAC or 277VAC; 50-60Hz
5. To prevent damage to electrical components it may be necessary to employ internally sealed conduit fittings or to fill all conduit
fitting throats to avoid water penetration of the unit. If sealant is used, a sealant compatible for use with solid-state electronics
should be used.
www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United States with more than 50% of the component cost of US origin. It may be covered by patents
found at www.kenall.com/patents. Content of speci cation sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg. Co.

IMPORTANT SAFEGUARDS

ORIENTATION, OR MOUNTING RESTRICTIONS.
SAVE THESE INSTRUCTIONS
2.35"
INSTALLATION INSTRUCTIONS
14.10"
9.50"
1
Figure 1
IC100_F-5986_070622