Advertisement
Quick Links
PRELIMINARY WARNINGS
The word WARNING preceded by the symbol
The word ATTENTION preceded by the symbol
instrument or the connected equipment. The warranty shall become null and void in the event of improper use or
tampering with the module or devices supplied by the manufacturer as necessary for its correct operation, and if
the instructions contained in this manual are not followed.
WARNING: The full content of this manual must be read before any operation. The module must only be used by
qualified electricians. Specific documentation is available via QR-CODE shown on page 1.
Electrical and electronic waste disposal (applicable in the European Union and other countries with recycling).
The symbol on the product or its packaging shows the product must be surrendered to a collection centre
authorized to recycle electrical and electronic waste.
SENECA s.r.l.; Via Austria, 26 – 35127 – PADOVA – ITALY; Tel. +39.049.8705359 - Fax +39.049.8706287
CONTACT INFORMATION
Technical support
This document is the property of SENECA srl. Copies and reproduction are prohibited unless authorised.
The content of this document corresponds to the described products and technologies.
Stated data may be modified or supplemented for technical and/or sales purposes.
MI00577-0-EN
INSTALLATION MANUAL
The module must be repaired and damaged parts replaced by the Manufacturer. The product is sensitive to
electrostatic discharges. Take appropriate measures during any operation.
support@seneca.it
INSTALLATION MANUAL
R-BT2
indicates conditions or actions that put the user's safety at risk.
indicates conditions or actions that might damage the
DOCUMENTATION
Product information
sales@seneca.it
1/4
Advertisement
Summary of Contents for Seneca R-BT2
- Page 1 The symbol on the product or its packaging shows the product must be surrendered to a collection centre authorized to recycle electrical and electronic waste. DOCUMENTATION SENECA s.r.l.; Via Austria, 26 – 35127 – PADOVA – ITALY; Tel. +39.049.8705359 - Fax +39.049.8706287 CONTACT INFORMATION Technical support support@seneca.it...
- Page 2 BATTERY PACK LAYOUT “EHR-2” 2-pole male connector Black (-) Red (+) SENSOR LAYOUT INDUSTRIAL SENSOR KEY: 1) Housing for the battery 2) Button used to pair the sensor and force communication with the R-GWR control unit 3) Analogue / digital input connection terminal 4) Terminal for the connection of the enhanced battery pack.
- Page 3 TECHNICAL SPECIFICATIONS CERTIFICATIONS POWER SUPPLY Rated voltage: 3.6V; Rated current: 4.4Ah TEMPERATURE From -55 °C to +85 °C RANGE ASSEMBLY Using EHR2 2-pole male connector ASSEMBLY CAUTION • Do not use sharp objects to remove the battery. • Old batteries cannot be disposed of in household waste, it is mandatory to return them to the appropriate collection place, prepared by the municipality or point of sale.
- Page 4 For the correct installation of the product, follow the instructions below: 1. Remove the sensor closing cover; 2. Remove the battery pre-installed in the housing; 3. Using the adhesive strip provided, apply the enhanced battery pack to the closing cover; 4.