Advertisement
1. To turn the insoles ON, press and hold the power button on the back of the insoles for 2
seconds or until you see a slowing FLASHING GREEN light.
2. To turn the heating ON, press again to change to the RED light (High). Press again to change
to the GREEN light (Medium). Press again to change to the BLUE light (low). Press again to go
back to the slowing FLASHING GREEN light (heating OFF).
3. To turn the insoles OFF (when the insoles are not in use or when storing), press and hold the
power button on the back of the insoles for 2 seconds or until the LED LIGHT TURNS OFF.
USING THE REMOTE CONTROL
1. To turn the insoles ON, press and hold the power button on the back of the insoles for 2
seconds or until you see a slowing FLASHING GREEN light.
2. To turn the heating on, press and hold the on/off button
for 2 seconds until a RED light (High) lights up.
3. To adjust the heat, press the corresponding letter on the wireless remote control. "H" is for
high heat (RED). "M" is for medium heat (GREEN). "L" is for low heat (BLUE).
4. To turn the heating OFF, press the On/Off button
control.
5. To turn the insoles OFF (when the insoles are not in use or when storing), press and hold the
power button on the back of the insoles for 2 seconds or until the LED light turns OFF.
• Note: The wireless remote control has a maximum range of 9.8 ft.
TEMPERATURE SETTINGS / DURATION
• High heat: 131°F, with approximate run time of 3 hours
• Medium heat: 113°F, with approximate run time of 4.5 hours
• Low heat: 95°F, with approximate run time of 8 hours
• Note: Above results are tested under an average room temperature of 82.4°F
TRIMMING TO FIT
• To fit different sizes of shoes, you may trim the front end in the area where it is marked.
• Do not cut over the wires.
• Do not puncture or tear into the lining of the product.
on the wireless remote control
once again on the wireless remote
-3-
Advertisement
