Download Print this page

Rosewill RPWF-21001 Quick Start Manual

PRODUCT OVERVIEW

Water Outlet

Water Basin

Filter

Filter Cover

Base

1. Remove the filter and rinse it with fresh water before use.

NOTE: It is recommended that this filter be replaced once every 1 to 2 months.

2. Remove the water basin from the water fountain and install the filter onto it as seen in the

diagram below.

NOTE: Make sure that the filter cover snaps into place on both sides.

3. Run the

power cable

water fountain.

Thank you for purchasing a Rosewill Automatic Pet Water Fountain.

Please read the instruction manual before use and retain for future reference.

attached to the water pump through the cable hole located inside the

RPWF-21001

Water Pump

Power Cable

Power Adapter

USB Cable

Table of Contents

Do you have a question about the RPWF-21001 and is the answer not in the manual?

Page 1 RPWF-21001 Thank you for purchasing a Rosewill Automatic Pet Water Fountain. Please read the instruction manual before use and retain for future reference. PRODUCT OVERVIEW Water Outlet Water Basin Water Pump Filter Night Light Filter Cover Power Cable Power Adapter...
Page 2 4. Add water to the water fountain until the water level is between the MIN and MAX lines located on the inside of the water fountain. Replace the water basin once the water is added. 5. Plug the USB-A end of the included USB cable into the included power adapter.
Page 3 NIGHT LIGHT The night light allows your pet to see the water in the dark. When the water level is low, the LED on the night light will flicker. Once the water level reaches above the top of the water pump, the LED will become solid.
Page 4 Technical Support Information techsupport@rosewill.com 1-800-575-9885 Please register your product at www.rosewill.com for complete warranty information and support for your product. RPWF-21001_A...