ReachFar V48-4G Installation And Operating Instructions Manual
  1. Manuals
  2. Brands
  3. ReachFar Manuals
  4. Watch
  5. V48-4G
  6. Installation and operating instructions manual

ReachFar V48-4G Installation And Operating Instructions Manual

Tracking smart watch
Hide thumbs
Table of Contents

Advertisement

Quick Links

Flexcom Kommunikációs Kft
Üzembehelyezési és használati útmutató (2021/11/23)
Installation and operating instructions
Reachfar V48-4G tracking smart watch
Introduction
In developing the products we offer, the manufacturers have acted with the utmost care and in
accordance with international standards.
Warranty
We offer a 12-month warranty on the products, which is valid from the date of purchase. Keep the
invoice or block you received at the time of purchase and / or the warranty card of the device,
because you can only enforce your warranty claim if you have them. During the warranty period, we
will replace any defective main unit, accessory or software of the product in the event of any defect
attributable to a manufacturing, material or software defect. Subsequent repairs to the device or its
accessories are not permitted by the manufacturer due to the design of the device.
The warranty does not cover a product (or accessory) that has been damaged or rendered inoperable
due to attempts to modify or repair the software, physical impact, poor voltage, improper use.
To ensure proper, effective and safe use of the product, read the instruction manual carefully and
keep it for future reference. Flexcom Kommunikációs Kft. Shall not be liable for any damage, product
damage, short-term or long-term health damage that may occur as a result of use, repair, storage
and transport other than those described in this manual.
Rights, trademarks
© 2019, Flexcom Kommunikációs Kft.
All rights reserved. No part of our printed or online publications may be reproduced, distributed or
transmitted in any form or by any means, including photocopying, recording or other electronic and
mechanical methods, without the prior written permission of the publisher. To obtain a permit,
contact your dealer:
Contact
1/29

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the V48-4G and is the answer not in the manual?

Questions and answers

Summary of Contents for ReachFar V48-4G

  • Page 1 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Installation and operating instructions Reachfar V48-4G tracking smart watch Introduction In developing the products we offer, the manufacturers have acted with the utmost care and in accordance with international standards. Warranty We offer a 12-month warranty on the products, which is valid from the date of purchase. Keep the invoice or block you received at the time of purchase and / or the warranty card of the device, because you can only enforce your warranty claim if you have them.
  • Page 2 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Flexcom Communication Ltd. 2151 Fót, Szent Imre str. 94. HUNGARY Email: info@nyomkovetes.net Website: https://nyomkovetes.net Office 2151 Fót, Dózsa György str. 34. HUNGARY Phone: +36 1 769 1005 Mobile 1: +36 70 3333 525 Mobile 2: +36 70 3333 527 Phone service: (Monday-Thursday) 9.00–15.00 Every effort has been made to ensure that the information in our documents is accurate.
  • Page 3 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Formats and notations The following style settings are used in descriptions, guides, and other documents: Name of product components, instructions, options, processes, services, user interface Bold text elements. Italic text Links to other publications, emphasis. Courier text System messages, internet addresses, document names.

  • Page 4: Product Description

    Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Product Description The device combines the functions of accurate positioning, safety, monitoring, emergency alarms and full tracking. It supports SMS / GPRS / Internet data transfer functions and is widely used in the areas of location-based services and personal security.

  • Page 5: How To Use

    Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) How to use You can use the device after charging, inserting a SIM card, and setting it up via SMS or a mobile phone or PC application. The device automatically connects to the GPS and GSM networks using the GPS receiver and the SIM card (if available) and starts collecting position data, which can be queried using an internet application.

  • Page 6: Safety And Handling

    Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Safety and handling Conditions for safe use of the product Information for people with long-term health problems or disabilities This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
  • Page 7 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) The product does not contain harmful, toxic substances. Its internal components, outer casing and accessories are not made of, or only slowly degraded, materials - an appropriate waste disposal procedure must be followed. Health Risks When used as intended, the product does not present a health hazard to humans, either in terms of materials, components or their function.

  • Page 8: Technical Parameters

    Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Technical parameters Physical characteristics Parameter Value Dimensions (mm) W: 42, L: 65, H: 20 Weight (g) Humidity from 5% to 95% (none condensing) Operating temperature -15C to 70C IPX7 (dust and water resistant, last up to 1 m and Water resistance 30 minutes) Memory...
  • Page 9 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Parameter Value Blood pressure and heart rate Temperature Removal Fall Interface Parameter Value GSM antenna Internal GPS antenna Internal Built-in microphone Built-in speaker SOS button Voice message button 9/29...
  • Page 10 The package consists of a box containing the device and its accessories. Unpacking Open the box. Remove the product. Remove the retaining insert to protect the device. Remove the accessories below. Contents of the package 1 Reachfar V48-4G tracking smartwatch 10/29...
  • Page 11 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) 1 USB cable 1 SIM needle 1 screwdriver 1 installation instructions Preparing the SIM card As with mobile phones, a SIM card is required to operate the device. The device communicates with the mobile service provider's network via SIM card, SMS or mobile phone or PC applications.
  • Page 12 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Setting up data traffic If you are using a software tracking service, you must activate GPRS (Internet) data traffic and enter the appropriate network settings. To do this, you need to send SMS messages from your phone to the phone number of the SIM card inserted in the tracking device, as shown in the table below.
  • Page 13 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Insert the SIM card as follows: Steps: Unscrew the protective cover. Insert the SIM card into the slot as shown. Screw the protective cover back on. Charging the battery The watch is powered by a built-in battery, which needs to be charged at different intervals depending on the intensity of use.
  • Page 14 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) During charging, the LED on the front of the watch flashes red slowly; when the battery is fully charged, the blinking turns solid. The charging time is approx. 2-3 hours. If the red LED flashes slowly during normal operation, the battery is running low and must be charged. A charger with a maximum current of 1 A may be used for the clock! Chargers with a higher capacity can damage the battery.
  • Page 15 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Scan the QR code shown here with your phone. Open the web address decoded from this. Install the Flexcom tracking application. For iPhones Use the browser on your phone to access the service (https://gpspositions.net/map/). Using the Product User Interface The connectors and controls of the device are located on the side under the protective cover and on...
  • Page 16 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Speed Dial Buttons (1,2) Speed dial preset phone numbers. The numbers can be entered using the software using the appropriate command sent to the machine (see later in the software settings section). You can end the call by pressing the SOS key once.
  • Page 17 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Slow flash Signal searching Red (GSM) Fast flash Signal received Bekapcsolva Slow flash Positioning Blue (GPS) Fast flash Position uploaded Slow flash Charging Solid Fully charged Charging Slow flash Charging Kék Solid Fully charged When the battery is low, the red LED flashes slowly Health sensor (back of the watch)
  • Page 18 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) The clock cannot be turned off with its own controls, only with a command sent from software. Normal operation of the device The device can be operated in the following ways: using the software service provided by the distributor and the SIM card together, in addition to the software service provided by the distributor but using his own SIM card, or without the service provider's software service, with your own SIM card.
  • Page 19 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) With Distributor software but with own SIM card After setting up and inserting the SIM card as described in the setup chapter, you must register the card. To do this, contact your software service provider (device vendor). From now on, the operation of the device is the same as described in the previous chapter.
  • Page 20 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Select the desired device on the map or in the menu. Click the Settings or Commands button to select the general setting or behavior you want. When using a mobile application: From the application menu, select Map.
  • Page 21 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Switch to the Tools panel. Find your device in the list of devices and tap the Setup icon next to the ID. Select the desired setting or, when sending a command, select Commands.
  • Page 22 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Device settings with Settings related to the commands Alarm settings operation of the software In the software, you can specify In the software, you can make In the software, you can make settings and actions by clicking settings by clicking the Alarms settings by clicking the Settings...
  • Page 23 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Search for the clock As a result of the command the watch beeps. Position update The command sends the clock's current position data to the system out of line. Scheduled position upload The device uploads its geographical coordinates to the central system at intervals...

  • Page 24: Temperature Measurement

    Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Setting the sleep time During the specified period, the watch measures the rotation of its owner (during sleep), or at the end of the period set here, the data of the previous step count and rotation measurements are deleted Wake up...
  • Page 25 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Fall sensor sensitivity How strong the impact should be that the watch perceive to be a fall. Medicine reminder Set and schedule a medication reminder message. Message Send a text message to the system that the software admin can read.

  • Page 26: Troubleshooting And Repair

    Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Troubleshooting and repair Conditions for safe use of devices Information for people with long-term health problems or disabilities This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
  • Page 27 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Identifying problems and possible solutions Symptom Possible cause Solution The device does not turn on or turns off The battery may be Charge the battery. immediately after turning exhausted. it on. Check the strength of the GSM connection. If the LED is solid amber, there is no connection to the No GSM connection.
  • Page 28 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) During the warranty period, if the conditions of the warranty have not been violated, the distributor will take care of the professional investigation of the cause of the failure, repair of the error or replacement of the device.
  • Page 29 Flexcom Kommunikációs Kft Üzembehelyezési és használati útmutató (2021/11/23) Decommissioning Disposing and destroying the device If you decide to stop using the appliance, do not throw it away with the normal household waste. The device is a complex structure and its components contribute to environmental problems to varying degrees.

Table of Contents