Before The First Use; Installing The Reader; Loading The Thermal Printer - Virbac Speed Reader User Manual

Before the first use

Installing the reader

o Place the reader on a clean, flat surface that is free from moisture
o Connect the two cables that constitute the power cord
o Connect the power cord to the rear of the reader at the level of the
power supply socket and to a 100-240V earthed power supply.
Only use non-rechargeable type AA/LR6 batteries. Never use Ni-Mh
rechargeable batteries or batteries of other types.

Loading the thermal printer

To change the paper roll, lift the printer cover, remove the old roll and
replace it with the new one. Close the cover. Ensure that the printing can be
performed properly by rolling out the beginning of the paper outside the
printer.
This printer only works with thermal paper.
The size of the thermal paper roll is:
57 mm x 40 mm x 12 mm
(Paper width X Maximum external diameter of the roll X Internal diameter of the coil)
Each time the Speed Reader
band in order to verify the presence of paper
The Speed Reader
batteries. This feature enables the device not to
turn off in case of a power failure (power is limited
to 30 minutes or about 3 tests).
TM analyser is booted, the printer rolls out a thin
TM analyser can be used with
7