Advertisement
FDM-S3 Downconverter Assembly – rev 3
1. Open the FDM-S3
Loosen the rear panel. Loosen the 4 screws that secure the rear panel, loosen the 6 nuts of the SMA
connectors and remove the 2 screws of the DB9 connector.
Remove the top cover. Once the screws have been loosened, move the rear panel slightly outwards
in order to remove the top cover. Attention, the bottom cover will also be free from the frame.
2021-11-04
1 / 5
Advertisement
Table of Contents
Related Manuals for ELAD FDM-S3
Summary of Contents for ELAD FDM-S3
- Page 1 FDM-S3 Downconverter Assembly – rev 3 1. Open the FDM-S3 Loosen the rear panel. Loosen the 4 screws that secure the rear panel, loosen the 6 nuts of the SMA connectors and remove the 2 screws of the DB9 connector.
- Page 2 Remove the RF-IN input cap so as to be able to insert the DCM (DownConverter Module) inside it’s housing. Here is a picture of the FDM-S3 open with the Downconverter inside : The Downconverter must be fixed to the lower panel by means of 4 screws and the 2 tab washers...
- Page 3 FDM-S3 Downconverter Assembly – rev 3 3. Connect the DCM Regarding connections : ensure the DWC-USB 5 wires cable is correctly connected to the RCMM, the USB-C cable must be connected between the RCMM and the DCM, the SMA bypass must be disconnected, connecting the male SMA connector to the female SMA connector of the Downconverter.
- Page 4 FDM-S3 Downconverter Assembly – rev 3 4. Close the FDM-S3 First try the FDM-S3 and DCM without closing the case (see 5 - Set and Check FDM-SW2), only once you have verified its correct operation, close the FDM-S3 proceeding in the opposite direction.
- Page 5 FDM-S3 Downconverter Assembly – rev 3 DCM and FDM-S3 details may be checked in the About tab, use the “Copy Info” button to send us detailed in case of any issue. 2021-11-04 5 / 5...
Need help?
Do you have a question about the FDM-S3 and is the answer not in the manual?
Questions and answers