English TOOLS REQUIRED Phillips Screwdriver - Not Included Standard (Flat Head Screwdriver) - Not Included Power Tools: Set to Low Torque RECOMMENDED Electric Screwdrivers may be helpful during assembly; however, please set a low torque and use extreme caution. High Torque: Over Tightened IMPORTANT NOTICE! This product is intended for INDOOR use only.
English PARTS IDENTIFIER PART NUMBER FIG NUMBER FOR FIG. 1 PART QUANTITY PART NAME Platform FOR FIG. 1 FOR FIG. 3 FOR FIG. 3 FOR FIG. 5 Platform Lock Pole with Hanger Hanger Hook Electronic Scorer with Belt HARDWARE FOR FIG. 1 FOR FIG.
Page 4
English ASSEMBLY FIG. 1 BOTTOM VIEW FIG. 2 Note: Open the bottom clip on the Lock. Repeat for both Platform Locks. FIG. 3 YUS916_067M (Continued on the next page.) www.medalsports.com...
Page 5
English ASSEMBLY FIG. 4 FIG. 3 Assembly FIG. 2 Assembly Note: Close the bottom clip Note: Slide FIG 3 Assembly through on the Lock. the Platform Lock on FIG 2 Assembly. FIG. 5 SIDE VIEW Press Note: Press in the push pins and insert pole into the Electronic Scorer.
Page 6
English ASSEMBLY FIG. 6 INFLATE DO NOT OVER INFLATE Diameter MAX: 8 inch CLOSE WARNING Inflation using an air pump must be performed by an adult. ● Do not use a high pressure pump to inflate the target such as air pump for car tire. ●...
Page 7
English ASSEMBLY FIG. 7 FRONT OF THE DOOR BACK VIEW Suction Cups Note: Make sure the Suction Cups on the back of the Electronic Scorer are up against the door. Note: Hang the unit on the door. BACK OF THE DOOR Note: Buckle the Safety Strap.
English ADJUST THE HEIGHT Note: Open the bottom clip on both Locks. Then slide the platform up or down, depending on the desired height. Note: Close the bottom clips on the Locks. YUS916_067M (Continued on the next page.) www.medalsports.com...
English ELECTRONIC SCORER OPERATION BATTERY INSTALLATION Battery Box: Unscrew the bolt using a screwdriver and open the battery box. Insert 2x1.5V AAA batteries ( not included) in the sequence of polarity as shown on the inside cover. Then close the cover using a screwdriver. REMINDING: The batteries must be installed according to their correct polarization (+ and -).
Page 10
English DISCLAIMER WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Need help?
Do you have a question about the YUS916 067M and is the answer not in the manual?
Questions and answers