Setting The Language - Toshiba 20A45C Owner's Manual

SETTING THE LANGUAGE

This TV can display the on-screen displays and adjustment menus in English, Spanish, or French.
The on-screen language selection (step 3, below) will automatically appear on the screen when you press the MENU button
initially. Select the language you prefer first, then proceed with the other menu options.
1
Press MENU.
2
Press SET + or – to select the
LANGUAGE mode, then press
ENTER.
NOTE:
If Spanish or French is chosen, the closed caption indicators will be in the selected language, but the closed caption text
will not be affected by the language selection.
TV OPERATION
1
To turn on the TV, press POWER.
2
The VOLUME can be adjusted to a desired level by
pressing VOL (VOLUME) + or –.
The sound level will be indicated on the TV screen by
GREEN BARS AND A NUMBER. As the sound level
increases, so do the number of BARS AND THE
NUMBER on the screen. The same is true for decreas-
ing the level.
3
Set the TV/CABLE menu option to the appropriate
position. When shipped from the factory, this menu
option is in the CABLE setting. See "TO MEMORIZE
CHANNELS" on page 9.
TV - VHF/UHF channels
CABLE - CABLE TV channels
4
CH (CHANNEL) + and – buttons
Press and release CH (CHANNEL) + or –. The
channel automatically stops at the next channel
programmed into the TV's memory. Press and hold the
button down to change channels more quickly.
For proper operation, make sure you program
channels into the TV's memory before tuning
channels. See "TO MEMORIZE CHANNELS
8
J3M91421A(E)_P08-12
〈 〉
" on page 9.
8
3
Press SET + or – until the "
indicator points to the desired
language: English (ENGLISH),
Spanish (ESPAÑOL) or French
(FRANCAIS), then press ENTER.
4
Press MENU repeatedly until the
menu screen is cleared.
DIRECT CHANNEL SELECTION buttons (0–9) - Press
these buttons to select a channel. The channel number will
appear on the upper right corner of the TV screen. If an
invalid channel number is selected, the display will revert to
the previous channel.
TV MODE DIRECT CHANNEL SELECTION - When the
TV/CABLE menu option is in the TV position, all channels
can be instantly selected by using two buttons (For example,
to select channel 2, press "0," then "2." If you press only "2,"
channel selection will be delayed for a few seconds). For
channels 10 and above, press the two digits in order.
CABLE mode direct channel selection
When the TV/CABLE menu option is in the CABLE position,
channels can be selected as follows:
1-9 Press "0" twice, then 1-9 as needed.
Example, to select channel 2, press
"002."
10-12 Press "0", then the remaining 2 digits.
Example, to select channel 12, press
"012."
13-99 Press the 2 digits in order.
Example, to select channel 36, press
"36."
100-125 Press the 3 digits in order.
Example, to select channel 120, press
"120."
NOTE: If the station being viewed stops broadcasting, the TV
will automatically shut off after 15 minutes.
11/03/2005, 3:34 PM
"
LANGUAGE / IDIOMA / LANGUE
ENGLISH
ESPAÑOL
FRANCAIS
〈 + / – / ENTER / MENU 〉