Advertisement
3. SPECIFICATIONS
Model No: ................................................................... VS260
Contents:
Direct Coil: ........................................................Ø20, Ø30mm
Pad Coil: ................................................................... Ø65mm
Flex Coil: ................................................................... 785mm
Power: .........................................................................1750W
Supply: ...........................................................................230V
Input Current: .....................................................................8A
Frequency (Input): ..........................................................50Hz
Duty Cycle: ....................................... 1.5mins on/ 1.5mins off
4. CONTENTS
fig.1
4.1.
ADDITIONAL COILS (not supplied)
Part No.
Description
VS2306
Induction Coil - Side Ø28mm
VS2411
Induction U-Coil 430mm
VS2410
830mm Induction Coil - Flex
VS2407
Ø32mm Induction Coil - Direct
VS2308
Induction Coil - Side Ø32mm
VS2304
Induction Coil - Side Ø20mm
VS2305
Induction Coil - Direct Ø28mm
5. OPERATION
WARNING! If the user has any metal on their person such as a watch, coins, jewellery or surgical implants etc. they must avoid the
‰
metal item getting close to the heater coil or heater gun to avoid damage by induction heating.
WARNING! Ensure that the heater is switched off and unplugged from the power supply when fitting coils or cleaning.
‰
WARNING! Allow the tool and coils to cool off before changing coils, cleaning, or storing.
‰
NOTE: The operating cycle of the induction coils is set for 1.5 minutes of heating and 1.5 minutes of cooling.
5.1.
Slacken off the hex head bolts on the underside of the gun and connect the coil ends to the two output connections on the handle.
Re-tighten hex head bolts to hold coil legs in place.
5.2.
Plug into mains supply and turn the unit on using the on/off rocker switch on the rear face of the unit.
5.3.
Place the coil in the required position and squeeze the trigger on the gun to operate the heater coil.
5.4.
The gun has an LED mounted on the top surface. See fig.2. The conditions indicated by the LED are listed in the table below.
LED Colour
Green
Green on when working
Orange
Red flashing
Red light on
Red and white light flashing
© Jack Sealey Limited
Part No.
Description
VS2307
Induction Coil - Direct Ø32mm
VS2301
Induction Coil - Direct Ø15mm
VS2302
Induction Coil - Side Ø15mm
VS2303
Induction Coil - Direct Ø20mm
VS2309
Induction Coil - Pad Ø55mm
VS2310
Induction Coil - Flex 740mm
Meaning
Standby/Ready
OK to use
Thermal fuse cutout
Allow to cool for approx 1.5 mins.
Heating operating
OK to use
Device overloaded
Change coil or keep coil 3mm from material.
Too high temperature
Release trigger and leave for approx 1.5 mins to cool down.
Missing or damaged coil
Check coil is properly fitted or change coil.
Original Language Version
fig.2
Troubleshooting
VS260
Issue 1
02/02/22
Advertisement
