Installation And Wiring; What's In The Box; Before Starting - Lanzar HTGEPBT9H User Manual

INSTALL ATION AND WIRING
Read these instructions and the following precautions carefully.

What's in the Box:

•
4-Band Parametric Equalizer

Before Starting

Mounting Precautions
The HTGEPBT9H can be mounted next to the source unit or under the dash using
the mounting brackets. The front panel controls should be easily accessible from
the driver's seat.
In addition:
•
This unit requires additional mobile audio components for proper operation.
•
Always use great care when attaching anything to a vehicle! Check clearances in
front of, behind, and on both sides of the planned installation before drilling
any holes or installing any screws.
Wiring Precautions
Disconnect the ground (-) terminal on the vehicle's battery.
WARNING!
To Prevent short circuits during installation, always disconnect the vehicle's
negative (-) battery lead before making any connections.
•
This unit is exclusively for vehicles with a negative ground, 12V battery system.
•
A good chassis ground connection is critical to minimize resistance and avoid
noise problems. Use the shortest wire possible and securely connect it to the
car chassis and the source unit ground.
•
When routing RCA cables, keep the cables away from the power cables and
output speaker wires.
•
If you are using a source unit without a remote turn-on lead, the HTGEPBT9H
can be turned on with a switched accessory lead. This accessory power source is
located in the factory harness at the back of the radio. This lead turns on and o
with the ignition key.
•
Do not open the case. There are no user-serviceable parts inside. If you require
assistance, consult your LANZAR dealer or an authorized LANZAR service center.
8
www.Lanzar.com