Advertisement
Tools needed:
Screwdriver
Step 1:
Secure right and left ends to the bottom of the Cable
Management Enclosure with 1/4-20" screws.
Step 3:
Secure the lock base just behind the grommet opening
with the 1/4-20" screws.
What's included:
QTY 1: Right End
QTY 1: Left End
QTY 8: M5x10 Screw
QTY 9: 1/4-20 Screw
Step 2:
A.
Detach the modesty panel from the leg kit.
B.
Remove screws from the rear leg kit that fasten it to the
table top.
C.
Slide the Cable Enclosure around the modesty panel.
D. Re-insert screws securing the modesty panel and cable
enclosure to the leg kit.
Step 4:
A.
Secure female hinges to the enclosure bottom with the M5x10
screws. Ensure hole openings face toward each other.
B.
Secure one male hinge to enclosure door bottom with M5x10
screws. Insert should be facing the outside of the door.
C.
Insert the installed male hinge into the female hinge. Take the
remaining male hinge and insert into the opposing female
hinge and secure to the door with M5x10 screws.
QTY 1: Bottom
QTY 1: Door
QTY 1: Lock Base
QTY 2: Male Hinge
QTY 2: Female Hinge
Advertisement
