Environmental Protection; Troubleshooting - Nakayama EC3010 User Manual

EN
Storage
Keep the charger clean and clear of debris.
Do not allow foreign material to get into the recessed cavity or onto the contacts. Wipe the charger clean with a dry cloth. Do not use solvents or water, and
do not place the charger in wet conditions.
Unplug the charger when there is no battery in it.
Charge the battery before placing it in storage.
Store the charger at normal room temperature. Do not store it in excessive heat.
Do not use the charger in direct sunlight or in damp conditions. Do not charge outside.
Recharge at room temperature. If the battery is hot, allow it to cool down before recharging.
Disconnect the power supply before maintenance or cleaning.
Repairs should only be carried out by qualified persons and using genuine spare parts. Inappropriate repairing could cause significant danger.
Always use bulbs according to specifications listed in this manual.
To maximize the life of the battery, Fully charge before storage.
• After charging, the battery pack may be stored in the charger, as long as the charger is not plugged in.
• Do not store the battery pack on the tool.
• Store the battery in a clean, dry place.
Cover it in order to provide added protection.

Environmental protection

Waste electrical products must not be disposed of with household waste.
According to the European Battery Directive, defective or used battery packs/ batteries, must be collected separately and disposed of in an environmentally
correct manner. Please recycle where facilities exist. Check with your local authorities or retailer for recycling advice. It will then be recycled or dismantled in
order to reduce the impact on the environment and for human health since they contain hazardous substances.

Troubleshooting

Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore, check the product using this section. In most cases the problem can be solved quickly.
Problem
The charger doesn't work
Red light and green light flash alternately
at a frequency of 1 Hz during operation
* If further assistance is required, take the unit to a qualified service dealer.
6
Possible cause
The charger is charging abnormally
The charger is broken
Temperature out of working range of the battery
pack
WWW.NAKAYAMATOOLS.COM
Solution
Contact an authorized service center.
Contact an authorized service center.
Remove the battery pack from the
charger,wait for 15 minutes to cool down.