Linking To Fitness Equipment; Device Information; Troubleshooting - Garmin HRM-PRO PLUS Owner's Manual

Table of Contents

Linking to Fitness Equipment

You can connect your heart rate monitor to compatible fitness equipment using ANT+ or Bluetooth technology

so you can view your heart rate on the equipment console.

• Look for the ANT+LINK HERE logo on compatible fitness equipment.

• Look for the Bluetooth logo on compatible fitness equipment.

Tips for Erratic Heart Rate Data

If the heart rate data is erratic or does not appear, you can try these tips.

• Reapply water to the electrodes and contact patches (if applicable).

• Tighten the strap on your chest.

• Warm up for 5 to 10 minutes.

• Follow the care instructions

• Wear a cotton shirt or thoroughly wet both sides of the strap.

Synthetic fabrics that rub or flap against the heart rate monitor can create static electricity that interferes

with heart rate signals.

• Move away from sources that can interfere with your heart rate monitor.

Sources of interference may include strong electromagnetic fields, some 2.4 GHz wireless sensors, high-

voltage power lines, electric motors, ovens, microwave ovens, 2.4 GHz cordless phones, and wireless LAN

access points.

Tips for Missing Running Dynamics Data

If running dynamics data does not appear, you can try these tips.

• Make sure your Garmin device supports running dynamics.

For more information, go to www.garmin.com/runningdynamics.

• Pair the HRM-Pro Plus accessory with your Garmin device again, according to the instructions.

• Make sure you are paired using ANT+, rather than Bluetooth.

• If the running dynamics data display shows only zeros, make sure the accessory is worn right-side up.

NOTE: Ground contact time and balance appears only while running. It is not calculated while walking.

(Caring for the Heart Rate Monitor, page

7).

Table of Contents