Sealy POWER PRODUCTS YG10.48 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT:
p
Familiarise yourself with the application, limitations and hazards of the generator.
3
Maintain the generator in good condition (use an authorised service agent). Replace or repair damaged parts. Use genuine parts only.
3
Unauthorised parts may be dangerous and will invalidate the warranty.
This generator is designed and manufactured for specific applications. Do not attempt to modify the unit or use it for any application for
3
which it is not designed. If you have any questions regarding the application of the unit please contact your local Sealey dealer.
p
at any one time - the total must not exceed the rated wattage of generator (see specification). In most cases the wattage of electrical
equipment can be found on the nameplate. If the nameplate gives only voltage and amperage, multiply the two to give rated wattage.
p
p
p
p
s
s
s
s
s
s
p
p
p
Operate the generator only on level surfaces (maximum allowable tilt is 10º) and where it will not be exposed to excessive moisture, dirt or
3
p
corrosive vapours or be in the proximity of combustible material (flammable liquids, solids or gases).
Remove ill fitting clothing, ties, watches, rings and other loose jewellery and contain long hair. Wear appropriate protective clothing.
3
Keep non-essential persons away from the work area.
3
p
p
p
use the generator for any purpose other than that for which it is designed.
7
p
operate the generator if any parts are missing or damaged, as this may cause failure and/or personal injury.
7
over-fill fuel tank. Always leave room for fuel to expand.
7
operate in the rain.
7
s
s
operate the generator when you are tired or under the influence of alcohol, drugs or intoxicating medication.
7
store generator with fuel in tank where fuel vapours might reach an open flame or spark.
7
DANGER! BE AWARE, LEAD-ACID BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION
AND THE ELECTROLYTE IS CORROSIVE. FOR THESE REASONS, IT IS VERY IMPORTANT TO READ AND FOLLOW
THESE INSTRUCTIONS CAREFULLY.
Follow these instructions and those of the maker of any equipment you intend to use in the vicinity of the battery. Remember to
review warning marks on all products and on engines.
3 When working with, or near, a lead-acid battery ensure that there is another person within hearing range of your
voice and close enough to come to your aid should a problem arise.
3 Wear safety eye protection and protective clothing. Avoid touching eyes while working near battery.
3 Have fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes.
3 Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool, clean
running water for at least 15 minutes and seek immediate medical attention.
3 Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit current
high enough to weld a ring or the like to metal, which would cause severe burns.
7 DO NOT smoke or allow a spark or flame in the vicinity of the battery or engine.
p DO NOT drop metal tools on, or otherwise allow them to touch, both battery terminals. The resulting short circuit could cause an explosion.
7 DO NOT cross connect power leads from starter to the battery. Ensure positive (+) (RED) is to positive and negative (-) BLACK is to negative.
,
INSTRUCTIONS FOR:
Model:
Add rated wattage of all equipment intended for connection
YG10.48 - 1 - 070703