Table of Contents
Advertisement
8 - Specifications
Message
R
Not Audio!!
Not Execute!
PGM Empty!!
PGM Full!!
R
PLL UNLOCK!
Ready Error!
R
Rec Error!
Servo Error!
T_Protected!
TOC Edited!
8–2
TASCAM MD-801R/P Mk II
Meaning and possible
remedy
No digital audio is available
when recording. Check the
source disc.
You attempted to perform an
invalid editing operation.
Read this manual to see
what you might have done to
cause this error message to
appear.
You are attempting pro-
grammed playback with no
program steps specified.
You have attempted pro-
grammed playback with more
than the maximum permissi-
ble number of tracks (see
6.2.1, "Entering programmed
playback").
This indicates a system error.
Try again with another disc. If
the error persists, contact
your TASCAM dealer.
An error occurred while load-
ing the flash start buffer from
disc (see 6.3, "Flash start").
Try loading the buffer again.
If this error persists, try with
another disc and check the
installation of the optional
BU-801 RAM buffer.
Some error occurred while
recording. This resulted in
the recording process being
stopped. Try again, using
another disc.
A disc error has occurred.
Eject the disc and try again,
or try with a different disc. If
this error persists, contact
your TASCAM dealer.
The track has been pro-
tected, and cannot be written.
Unprotect the track using the
procedure described in 5.9,
"Changing track attributes".
Not an error message—this
message is shown when you
try to eject a disc with
changes made to the TOC
EJECT
(see the
key expla-
[3]
nation—
).
Message
TRK Illegal!
R
UTOC Fixed!
UTOC Full!
W_Protected!
Write Fail!
8.2 Specifications
Changes in specifications and features may be made
without notice or obligation.
In the following specifications, 0 dBV is referenced
to 1 volt, and 0 dBu is referenced to 0.775 Vrms.
8.2.1 General MiniDisc
Format
MiniDisc (MD) format, 2-channel stereo
or mono using audio MiniDisc
R
Magnetic field modulation overwriting
Recording method
R
74 minutes (stereo), 148 minutes
Maximum recording
(monaural)
time
Sampling frequency
44.1 kHz
Compression system ATRAC (Adaptive Transform Acoustic
Coding)
Modulation system
EFM (Eight-to-Fourteen Modulation)
Meaning and possible
remedy
You have specified an illegal
track number for an opera-
tion. Make sure that the track
number matches the number
of tracks on the disc, and that
the track is a valid track for
the operation you are
attempting (i.e. it is not the
first or the last track for some
operations).
The U-TOC was found to be
defective, but the MD-801
successfully attempted a
repair. This restored U-TOC
was not saved to disc before
a recording operation was
attempted, causing this error
to be displayed.
The U-TOC is too full (com-
plex) for you to save the edits
that you have just made. You
may want to clean up the U-
TOC (see 4.3.2, "Rebuilding
the TOC").
You have attempted a record
or edit operation on a write-
protected disc.
The U-TOC could not be writ-
ten. Try loading another disc
to see if the error is in the
disk or in the MD-801
Advertisement
Table of Contents
