Advertisement
Quick Links
INSTRUCTION MANUAL: THE RIPPER
1. Turn off the power switch.
2. Using a phillips screwdriver open the
battery compartment.
3. Connect the battery wire to The
Ripper's connector as shown on the
diagram.
4. Close the battery compartment and
reinstall the screw.
5. Turn the power switch to On.
SETTING UP THE RIPPER
Power Switch
1
FOR
8+
AGES
Advertisement
Related Manuals for Odyssey THE RIPPER
Summary of Contents for Odyssey THE RIPPER
- Page 1 INSTRUCTION MANUAL: THE RIPPER AGES SETTING UP THE RIPPER 1. Turn off the power switch. Power Switch 2. Using a phillips screwdriver open the battery compartment. 3. Connect the battery wire to The Ripper’s connector as shown on the diagram.
- Page 2 3. Plug the USB cord into a 5v1a USB charger. 4. The charger light will turn on to indicate charging. When the charger light goes out charging is complete and you can reinstall the battery in The Ripper. Tip. Full charge takes up to 3-4hrs OPERATING THE RIPPER Tip.
- Page 3 The Ripper Steering Trim Adjustment Tip. If The Ripper pulls to the left or right when driving forwards without steering from the controller, you If the vehicle pulls to the left...
- Page 4 • Keep hair and loose clothing away from the vehicle when powered on. • If The Ripper will be stored and unused for an extended period of time, please remove the batteries. • Check the batteries regularly for potential leakage or corrosion that may occur.
Need help?
Do you have a question about the THE RIPPER and is the answer not in the manual?
Questions and answers
Need axles replacement