Ｄ】 Checking Keyboard And Midi; Ｅ】 Checking The Sound Source; Ｆ】 Checking The L/R Channel; Ｇ】 Checking The Hammer Sensor - Kawai ANYTIME X2 GP Service Manual

【D】 Checking Keyboard and MIDI
From the 【C】 " Checking the LCD" state, press the [Play/Stop] button one time.
The following message will appear on the LCD.
Connect MIDI IN with MIDI OUT in a loop using a MIDI cable.
Press any keys and check if the sound is emitted from the headphone (for the -f model, you can use the
speaker instead). If no sound is emitted, the MIDI board may be faulty.
※ Check first if all the cables are properly connected.
【E】 Checking the Sound Source
From 【D】 " Checking Keyboard and MIDI" state, press [ ▶ ] button repeatedly until the message below is
shown in the LCD display.
After this message is displayed, check if every key tone is emitted by half-tone from the lowest bass tone.
※ By performing this, it is verified that the sound source is functioning all over the diapason.
※ It is recommended to decrease the volume.
【F】 Checking the L/R Channel
From 【E】 " Checking the Sound Source" state, press the [ ▶ ] button. LCD display will show as below.
Use the headphone and check that a sound comes out from the L channel when the [EFFECTS] button is
pressed, and that the same happens from the R channel when the [REVERB] button is pressed.
※ It is recommended to decrease the volume since a pure tone will be emitted.
【G】 Checking the Hammer Sensor
From 【F】 " Checking the L/R Channel" state, press the [ ▶ ] button repeatedly until LCD display shows as
below.
When a key is pressed down, the sound will be emitted at the strongest touch regardless of how strong
you press.
Press down all the keys one by one and check if all of them emit a sound.
※ It is recommended to decrease the volume beforehand since sounds by the strongest touch will be
emitted.
※ If there is a key that does not emit a sound, the sensor may be faulty.
All manuals and user guides at all-guides.com
– 16 –