Table of Contents
Advertisement
3. Lighting configuration
Used to configure the light intensity in order to optimize reading
conditions. Press the upper half to increase the light intensity and
the lower half to decrease it. For systems that have LED lighting,
the intensity is adjusted by holding down the button (7).
4. Autofocus on/off
Press the button once to lock the focus. This can be used when
you wish to write by hand. Autofocus is not affected by the pen or
your hand. Press the button a second time, to reactivate
autofocus.
5. Zoom control
Used to set the zoom. To reduce the zoom, press the lower key
(minus) and to increase the zoom, pressure the upper key (plus).
6. Reference line/Bar
Adjust the position of the reference line. Press the right-hand
button to move the horizontal line down. Hold the button in to
change the reference line to vertical and move it to the left. The
reference line then becomes a horizontal bar which diminishes the
viewing area. To make the bar vertical, press the button again. The
left button gives the opposite result.
7. Picture mode
Press the button to switch the picture mode between natural
colours and grey scale.
Lighting adjustment
Hold the button down to temporarily enable adjustment of the
lighting via the lighting configuration (3). When the lighting
configuration (3) is used to adjust the lighting, there is no
switching between colour and grey scale (only possible if the
system has LED lighting).
Mirroring
A mirror image can be obtained by holding the button down for
three seconds.
8. High contrast modes with artificial colours
Press the key to switch between the various colour combinations.
Rotation
By holding the button down for three seconds, the image can be
rotated 180 degrees.
18
User Manual 7944987f | MagniLink S PREMIUM 2 -
MagniLink S PREMIUM 2 -
Chromebook
Chromebook
Advertisement
Table of Contents
