TRAINING MANUAL
NOISE FILTER
FRONT COVER
WM3001H*A
To service the noise filter, remove the
control panel cover.
Unplug the two connectors of the noise
filter and slide it out of the clips on the
frame.
See pages 67 and 75 for test information.
Remove the control panel and top cover
as shown on page 40 and set them aside.
Open the filter and drain cover.
Remove the screw securing the cover and
pry the cover out with a screwdriver or
putty knife. Be careful to avoid damaging
the rim of the opening.
With the filter cover removed, remove the
screw(s) that secure the base of the front
cover to the machine frame.
Remove the door gasket using special tool
383EER4001A to remove the outer
spring clamp.
Page 43
WM3001H*A
Washer