Advertisement
center place to make sure the wireless charging is high efficiency.
Charge power bank
(a) Use the Micro USB Cable or Type C Cable to connect power bank and 5V adaptor(or
computer or other power sources) to charge power bank
(b) During charging power bank, 4 LED lights is flashing: 1 LED light flashing means 25%
battery charging inside, 2 LED lights flashing means 50% battery charging inside, 3 LED
lights flashing means 75% battery charging inside, 4 LED lights flashing means 100%
battery charging inside. After fully charged, LED light will stop flashing and become 4 LED
lights always on.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation
This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This device generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this device does cause harmful interference to radio or television reception, which can be
determined by turning the device off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the device and receiver.
--Connect the device into an outlet on a circuit different from that to which the receiver is
connected.
--Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment
FCC Radiation Exposure Statement
The antennas used for this transmitter must be installed to provide a separation distance of
at least 20 cm from all persons and must not be co-located for operating in conjunction with
any other antenna or transmitter.
Advertisement
