Download Print this page

Outwater architectural products E-GLIDE EG.300 Series Instruction Manual

Ladder hardware

Advertisement

Quick Links

INSTRUCTION MANUAL
FOR INSTALLING
E-GLIDE LADDER HARDWARE
EG.300 SERIES
architectural products
OUTWATER
by
L.L.C.
24 River Road • Bogota, NJ, 07603 • 1.800.835.4400 • www.outwater.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the architectural products E-GLIDE EG.300 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Outwater architectural products E-GLIDE EG.300 Series

  • Page 1 INSTRUCTION MANUAL FOR INSTALLING E-GLIDE LADDER HARDWARE EG.300 SERIES architectural products OUTWATER L.L.C. 24 River Road • Bogota, NJ, 07603 • 1.800.835.4400 • www.outwater.com...
  • Page 2: Hardware Included

    Rail height determination: Distance from the floor to the location on the header board where the screw for the rail bracket will be fastened. • For the 92” ladder = 88 1/4” to 89 1/4” • For the 107” ladder = 103 1/4” to 104 1/4” Architectural Products by Outwater assumes no liability for improper installation. Page 2...
  • Page 3 After all the brackets are screwed to the wood header and the rail is in the intended position, tighten the small set screw on front of each bracket to the rail (figure 4). FIGURE 4 Architectural Products by Outwater assumes no liability for improper installation. Page 3...
  • Page 4 (figure 7). Align the mark on the top of the step to the front edge of the ladder side rail (figure 8). FIGURE 7 FIGURE 8 Architectural Products by Outwater assumes no liability for improper installation. Page 4...
  • Page 5 Using two 5mm Allen wrenches, tighten each side simultaneously so that there are equal amounts of thread on each side of the rod (figures 12 & 13). FIGURE 12 FIGURE 13 Architectural Products by Outwater assumes no liability for improper installation. Page 5...
  • Page 6 Follow this same procedure for all four through holes and complete the assembly by securing the top roller guide with the supplied nut caps and threaded rod (3-5). Architectural Products by Outwater assumes no liability for improper installation. Page 6...
  • Page 7 7/8” in from back edge of the side rail. • 2 5/8” and 7 7/8” down from the top of the ladder to center of hole for the fastener. Architectural Products by Outwater assumes no liability for improper installation. Page 7...
  • Page 8 Bottom Wheel Housing to the ladder side rail (using a 4mm Allen wrench and a 10mm open end wrench). (see the three images below). Architectural Products by Outwater assumes no liability for improper installation. Page 8...
  • Page 9 End Stop: • Length - 1 15/16” • Diameter - 1/8” Upper Hook Measurements: • Height - 1 13/16” • Width - 1 13/16” • Depth - 1 1/4” Architectural Products by Outwater assumes no liability for improper installation. Page 9...
  • Page 10 All 4 edges of the side rails, steps, and top of the - 92” OA length side rails shall have a 1/4” radius round over. - 107” OA length Material: Select or Better, Flat Cut Sanded to 180 grit Architectural Products by Outwater assumes no liability for improper installation. Page 10...
  • Page 11 APPLICATION PHOTOS OF E-GLIDE LADDERS Architectural Products by Outwater assumes no liability for improper installation. Page 11...
  • Page 12 REV. 08.13.20...