Advertisement
INSTALLATION
• For best performance, the Paint Gun Stand should be
mounted in a level position on a wall, cabinet, shelf,
workbench etc, capable of holding 10lbs. [4.5kg.] plus
pulling stresses from usage. The use of the included
screws for attachment to a structural member is highly
recommended.
• If mounting to a horizontal surface, it should be placed
near the edge to allow clearance for an attached air
supply hose.
• The Eastwood Concours Paint Gun Stand can be mounted
one of two ways: Four holes of the Base [A] using the
included 4 Long Screws to a horizontal surface or with
the back plate of the "L" Bracket [B] to a wall or other
vertical surface using the 2 Short Screws.
NOTE: If mounting to a studded wall with drywall or other
thicker covering it is recommended to use two of the
longer screws to mount into the stud.
USE
• Select the needed Cup Holder [E] or [F] based on the Gun
and Cup size.
• Set the Paint Gun into the Stand with the air cap oriented
toward the back of the Stand and the neck of the Gun Cup
cradled in the Cup Holder [E] or [F] (FIG 7).
• If a paint strainer is to be used, set it carefully into the
large, "O" Shape Frame [D] (FIG 8).
• Any unused attachments [C], [E] or [F] can be stored by
pushing the ends into various open receptacle areas of
the assembly.
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: tech@eastwood.com
© Copyright 2021 Eastwood Automotive Group LLC
If you have any questions about the use of this product, please contact
PDF version of this manual is available at eastwood.com
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA
800.343.9353 eastwood.com
FIG. 7
FIG. 7
FIG. 8
FIG. 8
3/21
Instruction item #55001Q
Rev 1
Advertisement
