Checking The Side Discharge Chute - Toro Z Master G3 Setup Instructions

8
Checking the Side Discharge
Chute
No Parts Required
Procedure
If there are plastic ties holding the side discharge chute
up, remove them and lower the chute into place.
WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury or
death. Also, contact with the blade could occur.
Never operate the lawn mower with the grass
deflector removed unless you install a cover plate, a
mulch plate, or a grass chute and catcher.
1. Make sure the L end of spring is installed behind
the deck edge before installing the bolt as shown in
Figure 9.
2. Place the J hook end of spring around grass deflector
(Figure 9).
Important: The grass deflector must be free to
rotate with downward tension. Lift the deflector
up to the full open position and ensure that it
rotates freely,without binding into the full down
position.
1. Grass Deflector
2. Spring
3. J hook end of spring
5
Figure 9
4. L end of spring, place
behind deck edge before
installing bolt
5. Deck edge