Summary of Contents for 247Blinds Plantation Shutter
- Page 1 Fitting & Caring for your Plantation Shutter Fitting Time – Approx. 45-60 minutes. 247blinds.co.uk Reviewed 06/12/2021 Next Review: 06/12/2023...
- Page 2 If fitting to masonry, drill and use the appropriate wall plug. If fitting to uPVC, once you feel the screw start to bite, stop drilling. Recommended Extras: Spirit level, Decorators Caulk & Packing material such as cardboard or wedges. 247blinds.co.uk Reviewed 06/12/2021 Next Review: 06/12/2023...
- Page 3 You should use the plastic Hoffman key and tap this into the holes to connect the frames. Do not use another frame piece to tab this in, something like a rubber mallet is more suitable. 247blinds.co.uk Reviewed 06/12/2021 Next Review: 06/12/2023...
- Page 4 3) Note that drill holes are not always pre-drilled into the frames, this is to allow you to fit the blinds as you require. Do not use all the screws, do not fully fix the frame until all the panels have been hung, as this allows any adjustments. 247blinds.co.uk Reviewed 06/12/2021 Next Review: 06/12/2023...
- Page 5 Then withdraw the screws. 8) Now remove each of the hinge pins and carefully take the panels down. Release the top screws which have been holding the frame in place and carefully take the frame down. 247blinds.co.uk Reviewed 06/12/2021 Next Review: 06/12/2023...
- Page 6 You may find over time that your slats lose some tension. Not to worry, this can be adjusted by using the slat tension screws, which are located on the inside edge of the panels. A quarter turn of the screw is enough to tighten to mechanism. 247blinds.co.uk Reviewed 06/12/2021 Next Review: 06/12/2023...
- Page 7 3) Remove the magnet from the receiver and screw the receiver into the indent. Place the panel into position, lining up the magnet and receiver. Tap panel front until the magnet meets the receiver to fasten the panels. 247blinds.co.uk Reviewed 06/12/2021 Next Review: 06/12/2023...
Need help?
Do you have a question about the Plantation Shutter and is the answer not in the manual?
Questions and answers