Advertisement
Revolabs Solo™ Single-Channel – Polycom
N
C
:
OTES AND
AUTIONS
This setup guide will guide you through the steps needed to properly connect a
Revolabs Single-Channel device to a Polycom SoundStation 2 speakerphone.
Note: It is important to carefully follow these instructions in order and completely. Otherwise,
your Single-Channel System and/or the phone may not function properly. Please read through
these instructions completely before proceeding. Contact Revolabs Technical Support if you
have any questions.
IMPORTANT: This will only work with the SoundStation 2 with LCD screen (expandable
version – P/N 2201-16200-601). The SoundStation 2 models without LCD screen or the
expandable capability do not have the ability to activate an external wireless microphone.
Requirements for connecting systems:
1. Revolabs Single-Channel system
2. Polycom SoundStation 2 speakerphone with LCD screen
3. Qty 1 Revolabs 2.5mm to RCA breakout cable (provided with single-
channel system)
®
SoundStation 2 Setup Guide
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Revolabs Solo Single-Channel
- Page 1 Requirements for connecting systems: 1. Revolabs Single-Channel system 2. Polycom SoundStation 2 speakerphone with LCD screen 3. Qty 1 Revolabs 2.5mm to RCA breakout cable (provided with single- channel system)
- Page 2 Connecting the Cables ONNECTING A REVOLABS FUSION TO OUND TATION SPEAKERPHONE 1. Connect Single-Channel to SoundStation 2 Auxiliary Audio Port using Revolabs 2.5mm to RCA cable...
- Page 3 4. Use Soft Keys Right to select WIRELESS MIC then press SAVE NOTES: 1. In this case, Revolabs only recommends using the wearable lapel microphone or using a third-party dynamic microphone with the Revolabs XLR adapter module. Please note that the volume levels of the Revolabs microphones are not adjustable.
Need help?
Do you have a question about the Solo Single-Channel and is the answer not in the manual?
Questions and answers