Advertisement
Quick Links
TI5.08-593ENG-REV1
SIRCHIE
®
Finger Print Laboratories
Website: www.sirchie.com
E-mail: sirchieinfo@sirchie.com
Getting Started
The MD700 is shipped
in 3 easy-to-assemble parts
(shown to the right): Upper
Handle, Extender Stem, and
Lower Search Coil Stem.
The only adjustments re-
quired after assembly of
the unit are the angle of the
search coil and the length of
the stem. Familiarize your-
self with the components of
the assembled unit shown
here before proceeding.
Padded Armrest
Initial Assembly and Setup
1. Carefully unpack the MD700. Save the carton and inserts for
future storage or shipment.
2. Note that the search coil cable is permanently attached to the
search coil. Be careful not to put any undue strain on it.
3. Insert the upper handle stem into the extender stem while
depressing the lock button. Push together until the lock button
lines up with the hole on the extender and locks. Twist the slip
nut to tighten this connection.
4. Insert the lower search coil stem into the other end of the
Copyright© 2008 by SIRCHIE
TECHNICAL INFORMATION
Metal Detection Sweeper
Catalog No. MD700
Control Panel
Finger Print Laboratories, Youngsville, N.C.
®
Phone: (919) 554-2244, (800) 356-7311
Fax: (919) 554-2266, (800) 899-8181
Search Coil Cable
Extender Stem
Slip Nuts (2)
Hand Grip
Battery Access (2)
100 HUNTER PLACE
YOUNGSVILLE, NC 27596 USA
Waterproof
ESI Shielded
Search Coil
Nylon Bolt
& Wing Nut
Lower Search
Coil Stem
Cable Connector
STEP 3
All Rights Reserved.
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for SIRCHIE MD700
- Page 1 Hand Grip Battery Access (2) Cable Connector Initial Assembly and Setup 1. Carefully unpack the MD700. Save the carton and inserts for future storage or shipment. 2. Note that the search coil cable is permanently attached to the search coil. Be careful not to put any undue strain on it. 3. Insert the upper handle stem into the extender stem while depressing the lock button. Push together until the lock button...
- Page 2 Adjust coil angle (using the nylon wing nut) so that the search coil rests flat on the ground. The MD700 is balanced for comfortable searching in a tight semicircle around the front of the operator.
- Page 3 2. Turn the DISC control ON, set it to 0 (zero) and set the SENS control to 8. 3. Hold the search coil about 2" (5cm) above and parallel to the ground. Move it slowly over the samples. You will hear sharp, loud responses as you pass over each one. NOTE: The MD700 is a motion-type detector. Therefore, motion of the coil is required to get a response. 4. Increase the DISC control setting to 3 and pass over the targets again. Continue to repeat this process for the remaining settings 4-10.
- Page 4 TI5.08-593ENG-REV1 4. Keep the search coil moving at a comfortable rate. NOTE: The MD700 is a motion-type detector. Therefore, motion of the coil is required to get a response. PINPOINTING TARGETS Pinpointing takes practice! The more experience you have using the unit, the better, faster and more accurate you will become. 1. Once a buried object is indicated with the unit by a beep response, simply place the coil lightly on the ground away from the target area. Push and hold the PINPOINT button (at maximum sensitivity,...
Need help?
Do you have a question about the MD700 and is the answer not in the manual?
Questions and answers