Comfort365 WLDCK Installation Manual

Comfort
D y n a m i c A i r f l o w C o n t r o l
The WLDCK Kit includes:
WLDC Wireless Damper Control.
(1) CR2450 Coin Cell Battery.
DDC2 Damper Control Module.
The WLDC is prelinked to the DDC2 and automatically
links when powered.
CAUTIONS
!
Not intended as a zoning system. See eControlsUSA.com for
zoning solutions.
Turn off power to HVAC equipment before installing or
servicing airflow controls.
Read and follow all instructions carefully.
Read entire manual before installing products.
Follow all local electrical codes during installation. All
wiring must conform to local and national electrical
codes.
Installation should be performed by a qualified
individual with sufficient experience and skill.
Use cautions when mounting components to surfaces
that may have concealed wiring beneath the surface.
WLDC Wireless Damper Control Wiring Diagram
WLDC Wireless Damper Control
Installed on any wall.
Step 1. Install the DDC2 Damper Control
The DDC2 Damper Control is installed near the HVAC
equipment on a non-metal surface using the hardware kit.
To remove the cover, press the
plastic tabs in the area indicated.
365
Model DDC2
Wireless Damper Control
24VAC, 4VA
Patent US 10,520,212 B1
Made
eControls, Inc., Laguna Hills, CA
in the
eControlsUSA.com
USA
Contains Transmitter Module
FCC ID OA3MRF89XAM9A
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Wireless Direct Damper Control
Patent US 10,520,212 B1
Compatible with R80CJ-XX Dampers (unsealed) or
R80JZD-XX Dampers (sealed).
DDC2 Damper Control Module
Installed near equipment
Model DDC2
Wireless Damper Control
24VAC, 4VA
Patent US 10,520,212 B1
Made
eControls, Inc., Laguna Hills, CA
in the
eControlsUSA.com
USA
Contains Transmitter Module
FCC ID OA3MRF89XAM9A
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Step 2. Wire the DDC2 to the Equipment
Connect the DDC2 Damper Control to R and C terminals at the
equipment using 2 conductor, 18 or 20 ga. thermostat cable.
Damper Control
Installation Manual
Model WLDCK
Jan 2022 Ver 200/ 201
Model DDC2
Wireless Damper Control
24VAC, 4VA
Patent US 10,520,212 B1
Made
eControls, Inc., Laguna Hills, CA
in the
eControlsUSA.com
USA
Contains Transmitter Module
FCC ID OA3MRF89XAM9A
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Damper sold separately.
R80CJ or R80JZD Damper.
Installed in the duct
controlling airflow to the space.
Plug&Play Cable Included
To 24VAC (R and C)
2
at the equipment or
24VAC, 40VA transformer.
TS
TS
R R
C C
DDC2
HVAC
System