. CAUTION DANGER Gallaria shall not be liable for any loss arising from the failure to comply with the following: Refers to a potentially dangerous 1. This toilet is considered to be a Class I (1)
SAFETY ADVICE To avoid the risk of electric shock, short- circuiting, fire, water leakage and damage to the product: DO NOT Insert or remove power plug with wet hands. DO NOT damage the power cord and plug. Inspect both before installation to ensure all is intact.
Page 9
Installation must be performed by qualified and licensed tradesmen. Failure to do so may result in damage to property, personal injury or death. DANGER Ensure water and electrical connections are plumbed/roughed into place before TAKE NOTICE installation. intelligentbathrooms...
Page 11
Model of bidet seat pictured Model of bidet seat pictured above for illustrative above for illustrative purposes only. purposes only. intelligentbathrooms...
Page 14
OVERVIEW Female Wash Rear Wash Stop Stage Indicator Decrease Flow Increase Flow Decrease Position Increase Position Decrease Water Increase Water Temperature Temperature TAKE NOTICE The remote control requires 2 x batteries, Type CR2032 (Batteries are not included) intelligentbathrooms...
Page 15
GENERAL CARE & CLEANING ADVICE TOILET PAN COMFORT+ SEAT Soft, lint free cloths Soft, lint free cloths Non-abrasive, mild cleaning Low acidic cleaning agents agents Toilet brush SUGGESTED INTERVAL SUGGESTED CLEANING ACTIVITY Daily Wipe down water droplets with a soft lint free cloth to avoid limescale stains.
FILTER REPLACEMENT The filter has a service life of approximately 6 months. Naturally, this is dependent on the harshness of water the filter is subjected to. If the filter is not replaced at the suggested interval of 6 months, then we recommend that it be replaced when the wash flow is noticeably reduced.
NOZZLE CLEANING The nozzle will automatically clean itself before washing and after washing. Should you wish to clean the nozzle manually, please do as follows: A. Press and hold down simultaneously the Female Wash and Stop buttons on the bidet seat for approximately 5 seconds.
DRAINING THE WATER TANK 1. The water and power must be cut before you disassemble the bidet seat 2. Do not invert or tilt the bidet seat before the water tank is fully drained DANGER Note: Model of bidet seat pictured above for illustrative purposes only.
Page 19
REMOVING THE SEAT COVER AND SEAT intelligentbathrooms...
Page 20
For further information or help, please contact us: (02) 8985 2619 Head Office: 27 Helles Avenue, Moorebank, NSW 2170 www.gallaria.com.au intelligentbathrooms...