AEG LAVAMAT 50265 ELECTRONIC User Information page 30

Operating Instructions
Problem
Washing is heavily
creased.
The washing has
not been spun as
dry as usual.
Washing is not
thoroughly spun,
water remains visi-
ble in the drum.
The indicator
L (END) flashes
twice.
The door cannot be
opened when the
washing machine
is on.
O/s (START/
PAUSE) and K
(DOOR) lights come
on.
30
Possible cause
Probably too much washing
has been put in the drum.
The washing was not able to
be distributed evenly in the
drum prior to spinning.
The drain hose is kinked.
The maximum pump height
(outlet height 1 m from
the base of the appliance)
is exceeded.
The drain pump is blocked.
For siphon attachments:
the siphon is blocked.
Door is locked due to high
water level, or high tempera-
ture.
Remedy
Pay attention to the maximum
load quantity (see Programme
Tables). In the case of easy-
care fabrics, select the
< (EASY IRON) programme.
Always load the drum as ful as
possible with a combination of
large and small items.
Remove the kink.
Contact your local Service
Force Centre. For pumping
heights over 1 m a conversion
kit is available as a special ac-
cessory.
Switch off the machine and
disconnect the mains plug.
Clean the drain pump.
Clean the siphon.
Wait until the programme has
ended, the K (DOOR) light
goes off and the L (END)
light is lit.
If it is necessary to open the
door immediately,
Turn the programme selector
to I (OFF); then turn it to
v (DRAIN). Press the O/s
(START/PAUSE) button.
When the water has been
pumped out, the door can be
opened.