Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for PENTAGON TranquilGuard
Summary of Contents for PENTAGON TranquilGuard
- Page 1 MOTOR OPERATION Face of Wall Mount INSTALLATION INSTRUCTIONS...
-
Page 3: Pre-Installation Information
PRE-INSTALLATION INFORMATION INSTALLATION INDEX Preparation --------------------------------------------------------------------------------------------------------------------------------------------------- Page 4 Mounting -------------------------------------------------------------------------------------------------------------------------------------------------------- Page 5 Complete -------------------------------------------------------------------------------------------------------------------------------------------------------- Page 13 TOOLS YOU WILL NEED Ladders (If required for height of Cordless Drill with #2 Robertson 3/4” Drill Bit (If required to drill a the opening) hole for the wire) 4 Foot Level Tester Cable (For testing the screen during... -
Page 4: Bottom Bar
PARTS The axle, curtain, and bottom bar are pre-installed inside the box housing. With multiple parts pre-installed in the box housing, the only visible parts are the box housing and the guide rails. BOX HOUSING CURTAIN (Pre-Installed in Box Housing) Size will vary depending on screen height and width Size will vary depending on screen height and width GUIDE RAILS... -
Page 5: Installation Screws
HARDWARE Hardware can be found in the installation package provided with the screen. If some of the hardware listed below is not included, this means your screen does not require it. INSTALLATION SCREWS BX CONDUIT (If Required) #10 - 2 Inch Screws Tek Screws BX Connector BX Conduit... - Page 6 PREPARATION 1. Remove the protective plastic on the exterior of the box housing (A). 2. Ensure the entire mounting surface is completely flat. You will need the width of one guide rail (C) on each side of the opening face, and the height of the box housing (A) above the opening.
- Page 7 MOUNTING 2 1. Mount the guide rails (C) to the sides of the opening face, using a level to ensure they are straight. Follow the steps shown below to remove the guide rail access panel and insert the screws through the guide rails at 16”...
- Page 8 2. Determine where the wire exit is on the box housing (A). There is a wire exit hole. The wire exit may be on either end of IB11 the screen box housing. (WIRE INSIDE BOX) NC10 If your wire exit is on the back of the box housing (NC7 or NC10): You will need to drill a hole in the wall for the wire to go through.
-
Page 9: Important Note
4. Lift the box housing (A) up and into position over top of the guide rails (C). Lower the box housing onto the guide rails, sliding the box housing legs into the outside channel of the guide rails. Ensure the bottom bar and curtain enter the guide rails correctly, so that the zipper on the screen is threaded into the guide inserts inside the guide... - Page 10 COMPLETE 1. Replace the box housing (A) cover lid and secure it with the two screws you removed in stage 1 of the installation. 2. Using your tester cable, test the operation of the screen. Operate it down and then up to ensure the screen is installed correctly and the curtain runs smoothly.
-
Page 11: Contact Details
YOU HAVE COMPLETED THE INSTALLATION OF YOUR TRANQUILGUARD SCREEN, CONGRATULATIONS! For technical support on the installation of your screen, please contact Pentagon. CONTACT DETAILS: Phone: 1.866.705.4668 Email: sales@pentagonshutters.com Website: www.pentagonshutters.com TECHNICAL SUPPORT... - Page 12 DOIIDTRFW www.pentagonshutters.com...