Advertisement
Ready To Go
200.55-Privacy Screen
Installation
1
Drill Pilot Holes
Using the Privacy Screen Installation Template provided, layout
the intended configuration of the privacy partition. Use the
base plates (3-15-2133) with spacer piece (3-15-2155) to lay out
the entire configuration. Drill Pilot hole in the center of the slot
on the base plates (3-15-2133).
Substrate
Diameter
Wood
concrete
*3form stocks the drill bits required for the pilot holes.
If you wish to purchase a drill bit, please contact your
3form sales representative.
3
Attach Bottom U Channel
a
cut U channel Glazing (3-15-2194)
to length of U channel.
For more information, please visit 3-form.com or call 800.726.0126
December 2019 | mAN-rTG-200-55 | reV 002 © 2019 3form, Inc. All rights reserved.
3-15-2155
3-15-2133
Drill Bit *
Depth
5/32"
3-15-2336
min 31/4"
1/4"
min 3"
tm
2
Center
of Slot
Anchors
3-15-2199
3-15-2144
b
Lineup U channel Glazing over U channel and drill 5/16" diameter
holes in the U channel Glazing where the countersunk holes of the
U channel are.
c
U channel Glazing channel (3-15-2194) for
flush mount U channel will have
holes for countersunk
screw access.
Installation Manual
Install Baseplate
Before fastening ensure the side with
countersunk holes lines up with the slot of
the End Post.
3-15-2155
3-15-2133
4
Advertisement
