RHS HANBURY ARCH and PLANTERS Assembly Instructions

Care and Maintenance
Your new garden item is a natural timber product. In order that you may
prolong the life of this product, we recommend that you follow the
general care and maintenance advice below.
All fixings to be checked for tightness and signs of deterioration at the
beginning of each season and on a regular basis.
We recommend that this product is positioned on firm level ground. If
necessary the product can be firmly fixed to the ground by using a
proprietary ground anchor.
The timber used in the product is pressure treated in accordance with BS
8417:2011 to provide protection against biodeterioration in end use
situations. It is possible that under some environmental conditions that a
surface mould may develop, should this happen clean off with mild
soapy water.
Product should be checked regularly, and re-coated with a suitable
topcoat finish when required. If accidental damage occurs, lightly sand
and re-coat with a suitable water based wood preservative. Product can
be cleaned periodically with a mild soapy detergent.
This is a natural product and therefore colour may vary slightly from
piece to piece. As a natural product it is possible that knots can work
loose and sometimes fall out, also resin leakage and small cracks can
appear on the woods surface. Should this happen, clean off resin, ensure
any sharp edges are sanded smooth and recoat.
Products should be given suitable protection from adverse weather
conditions, particularly during the winter months.
Please retain these instructions for future reference and use.
Helpline 01302 761573
Monday to Friday 9am - 5pm
HANBURY ARCH and PLANTERS
ASSEMBLY INSTRUCTIONS
Contents
Components
(A) x2 Arch side
(B) x2 Planter front (C) x2 Planter back
(F) x2 Curved rail
Fixings
(1) 16 x 90mm Allen Screw
(2) 8 x 50mm Woodscrew
(3) 10 x 60mm Woodscrew
Tools required
Pozi-drive screwdriver
Allen key (supplied)
(E) x8 Floor slat
(D) x2 Planter side
(G) x5 Toprail