Personalisations; Setting The Temperature; Setting The Spin Cycle; Functions - Hotpoint WT 400 Instructions For Installation And Use Manual

Personalisations

Setting the temperature (Variable Temperature )
Turn the VARIABLE TEMPERATURE knob to set the wash temperature (see Programme table on page 8).
The temperature can be lowered, or even set to a cold wash (No Heat).
Setting the spin speed (Variable Spin)
Turn the VARIABLE SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes Maximum spin speed
Cotton 1000 rpm
Synthetics 800 rpm
Wool 600 rpm
Silks no
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting “No Spin”.
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum
speed for each programme.

Functions

To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.
Function Effect
Time Delay Delays the start
of the wash by
up to 9 hours.
Super Wash Allows for an
impeccable wash,
visibly whiter
than a standard
Class A wash.
Reduce This option
Creases reduces the
amount of
creasing on
fabrics, making
them easier to
iron.
Extra Rinse Increases the
efficiency of the
rinse.
All manuals and user guides at all-guides.com
Comments
Press the button repeatedly until the LED corresponding to
the desired delay is turned on.
The fifth time the button is pressed, the function will be
disabled.
N.B.: Once you have pressed the Start/Reset button, the delay
can only be decreased if you wish to modify it.
If you set this option, programmes F, G, H, L and Delicate Rinse
will be suspended, leaving the laundry to soak (Anti-crease)
and icon will flash:
- to conclude the cycle, press the START/RESET button;
- to run the draining cycle alone, set the knob to the relative
symbol and press the START/RESET button.
Recommended when the appliance has a full load or with large
quantities of detergent.
GB
Enabled
with
programmes:
All
A, B, C, D,
E, F, G, H
All
programmes
excepts for
A, B, J, K
and Rinse
cycles
A, B, C, D, E,
F, G, H and
Rinse
cycles.
9