TVS Kiro 5 Mounting Instruction page 5

English – Mounting Instruction for towel radiator - 1400 x 510 mm
Read all the instruction before using.
Check that you have all the parts according to the packing list below. Contact your dealer if any part is
damaged or missing.
Contain of the box:
- 1 pcs. Towel radiator
- 2 pcs. Blind plug
- 1 pcs. Bleeder plug
- 4 pcs. Screws
- 4 pcs. Plug for drill hole
- 1 pcs. 10 mm spanner
Mounting:
Step A:
Decide where the towel drier is to be installed. Make sure the wall will support the rack and hanging wet
towels. Brick or concrete walls are ideal. If the drier is to be mounted on plasterboard, it must be secured
with wooden joists.
Step B:
Follow the instructions on the last page.
PLEASE NOTE - The measurements shown are approximate. The fitter must check the final positions of
where holes are to be drilled with the product itself and not rely solely on these dimensions.
Installation:
- If you use the towel radiator together with a heating element please read the instruction of the heating
element before installing the radiator.
- The towel radiator may only be installed into a close heating system - not on the tap water system.
- The pressure of the heating system may not exceed 12 bars.
- You may not climb on the towel radiator.
Advise for caring:
- The unit must be switched of while cleaning it.
- The easiest way to remove dirt, lime scale and other deposits is with soap and water. Rinse clean and
polish with a cloth or terry toweling. Avoid scouring powder or cleansers that contain abrasives, acid or
ammonia.
Dok. 212-5/2014