Dismantling The Device - ohmex PAS 2200 Instruction Manual

PAS 2200
CLEANING AND MAINTENANCE
> > Dismantling the Device
• Dismantle the device each time before you clean it so that you can clean all accesso-
ries with warm water. If necessary, allow stubborn remnants of dough to soften for a
little while in warm water:
1. Unscrew the locking ring.
2. Remove the pasta attachement.
3. Open the lid by pressing together the locking clip and pulling the lid up at the
same time. Remove the lid.
4. Disengage the connecting piece by turning it anticlockwise (in the opposite di-
rection to the arrow marked on the mixing container).
5. Pull the connecting piece together with the dough screw conveyor and the
kneading spiral out of the mixing container.
6. Remove the kneading spiral from the drive shaft of the dough screw conveyor.
7. Remove the connecting piece from the dough screw conveyor.
8. Take the mixing container off the motor unit.
> > Storage
1. Reassemble the device after cleaning once all of the individual parts have dried com-
pletely (see the "Assembly" chapter).
2. Store the device in a dry, clean place that is not accessible to children.
EN
67