1. Manuals
  2. Brands
  3. ACT Manuals
  4. Test Equipment
  5. DX 240
  6. Manual

ACT DX 240 Manual

Network cable tester
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
DX 240 Network Cable Tester

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DX 240 and is the answer not in the manual?

Questions and answers

Related Manuals for ACT DX 240

Summary of Contents for ACT DX 240

  • Page 1 DX 240 Network Cable Tester...

  • Page 2: Table Of Contents

    6.0 Warning and points of attention ................7 7.0 Warranty conditions ....................8 1.0 Introduction Congratulations with the purchase of this high-quality ACT product! This product has undergone extensive testing by ACT’s technical experts. Should you experience any problems with this product, you are covered by ACT warranty.

  • Page 3: Operation

    1. RJ45 JACK 2. RJ45 JACK 3. LED DISPLAY FOR SOURCING END (JACK 1) 4. LED DISPLAY FOR RECEIVING END (JACK 2) 5. POWER SWITCH 6. LED SCANNING MODE SWITCH 7. TEST SWITCH FOR MANUAL SCAN 8. RJ45 JACK 9. LED DISPLAY FOR RECEIVING END (SAME AS JACK 2) 10.

  • Page 4: Rj11 Modular Cable Test

    4. Once both ends of the cable are plugged in properly, the second row of LEDs will illuminate according to the corresponding LEDs in the top row. 5. Read the results of the LED display for the pin configuration status of the tested cable.

  • Page 5: Remote Test

    Manual mode, pressing the square "Test" button will advance testing to the next pin. Note: The center pin of BNC should be read on LED 2. Please refer to the diagram below 2. As Coaxial cable has only two wires, we suggest you read the result of the LED scan using Manual mode.
  • Page 6 Caution: 1. Operating the tester in live circuits may damage the tester 2. Leaving the battery in the tester for long periods of time without use could drain power from the battery...

  • Page 7: Frequently Asked Questions And Other Related Information

    A power socket is needed which should be close and easy accessible from the device. Repairing of the device should be done by qualified ACT staff. Never try to repair the device yourself. The warranty immediately voids when products have undergone self- repair and/or by misuse.

  • Page 8: Warranty Conditions

    ACT warranty. Products are not covered by the ACT warranty when exposed to incorrect/improper use, external influences or when opening the service parts of the product by parties other than ACT. ACT may use refurbished materials for repair or replacement of your defective product. ACT cannot be held responsible for changes in network settings by internet providers.

Table of Contents