FA Parkes 60129 Instruction Manual

Page 1
Digital Electronic Combination Lock
KEYPAD
'Unlocked' indicator light
HOW TO OPERATE
Locking/Unlocking
To Unlock
1. Enter factory default passcode 1234 + OK or enter factory default Management Passcode 4321 + OK.
2. Long beep will sound.
3. Green indicator light
4. Rotate the knob 90° within 3 seconds to open the lock. If the wrong passcode is entered, a beep will sound 3 times.
5. If lock shows red light
NOTE: When entering Management Passcode to unlock, user passcode will be changed back to default 1234.
To Lock
1. Rotate the knob back to lock position.
SETTINGS
1. Change passcode
1. Enter current User Passcode + OK, or Management Passcode + OK . Long beep will sound and
displayed.
2. Press OK for at least 2 seconds, then
3. Input new passcode, press OK. When you hear a long beep passcode has been changed.
NOTE: Passcode can consist of 4-15 digits. Management Passcode and User Passcode can not be the same code.
2. Turn on public mode, set temporary password
1. Enter current Management Passcode +OK , a long beep will sound and Unlocking indicator light
displayed
2. Press OK for at least 2 seconds, Unlocking indicator light
3. Input "4 4" and press OK. When you hear a long beep public mode has been set.
'Low power' indicator light
will come on
this indicates low battery level.
will flash.
Instruction Manual
BATTERY COMPARTMENT
USB KEY INTERFACE
will flash. Press OK again.
Part No. 60129
will be
will be