Edge-Core SAF51003I Quick Start Manual

Quick Start Guide
Network Security Platform
SAF51003I
1. Network Security Platform SAF51003I
2. Four adhesive foot pads
3. AC/DC Power Adapter
Note: The device is an open platform with Ubuntu Linux
pre-installed, but no application software.
1
Desktop Mount the Device
1. Attach the four rubber foot pads to the base of the device, and
then place it on a desktop or shelf.
2
Ground the Device
1
1. Ensure the device is properly grounded in compliance with ETSI
ETS 300 253. Verify that there is a good electrical connection to
the grounding point (no paint or isolating surface treatment).
2. Attach the grounding wire (#14 AWG) to the grounding point
on the device rear panel. Then connect the other end of the wire
to ground.
All manuals and user guides at all-guides.com
1
1
2
Package Contents
2
3
4. Power Cord—either Japan, US, Continental Europe or UK
5. Console Cable—RJ-45 to DB-9
3
Connect Power
1
2
1. Connect the AC/DC power adapter to the DC jack on the
device.
2. Connect the AC/DC power adapter to an external AC power
source.
4
Verify Device is Powered On
1
1. Verify the device is powered on by checking the PWR LED.
When operating normally, the PWR LED should be on green.
5
Connect Network Cables
1. For the RJ-45 ports, connect 100-ohm Category 5, 5e or better
twisted-pair cable.
– 1 –
4 5
1
E082018-AP-R01
150200001998A