Table of Contents
Advertisement
Quick Links
Contents
FIST wall mountable rack
1 Introduction
4 Mounting the WR2
onto the wall
1 Introduction
The FIST Wall Mountable Rack, FIST-WR2, is an all-purpose metal indoor rack designed to accommodate the
FIST generic shelf family (ETSI and 19").
It offers dust-proof, environmental and mechanical protection for the fiber management functions of splicing,
patching and passive component integration.
FIST-WR2 is designed for indoor applications and is designed to attach to a wall. A separate wall attachment
frame is included in the kit and allows hanging up the rack in a user-friendly way.
To clean FIST components, the use of isopropylalcohol is recommended.
FIST-WR2
I N S T A L L A T I O N
5 Preparing the rack for cable termination
and shelf mounting
5.1 Position of shelfs in the rack(ETSI,19"..)
5.2 Changing the CAP position
6 Cable termination in rack
I N S T R U C T I O N
Advertisement
Table of Contents
Summary of Contents for Tyco Electronics FIST-WR2
- Page 1 It offers dust-proof, environmental and mechanical protection for the fiber management functions of splicing, patching and passive component integration. FIST-WR2 is designed for indoor applications and is designed to attach to a wall. A separate wall attachment frame is included in the kit and allows hanging up the rack in a user-friendly way.
- Page 2 Remove the wall attachment frame by removing the two bottom bolts (B) completely and releasing the two top bolts (A) partly. (4 turns clockwise) Open the back of the package. All labels are on the front side. Remove the FIST-WR2 from it.
- Page 3 Mounting the FIST-WR2 onto the wall Place the wall attachment frame against the wall and mark the holes on the wall. Drill the 6 holes and place the plugs. Fasten the wall attachment frame on the wall. Tighten the bolts inside the rack to secure the rack on the wall...
- Page 4 Select a plate with the knock out ports according to the glands to be used. If needed, the plates can be changed or moved by unscrewing the 4 screws. Open the knock out ports, using a hammer and screwdriver and install the selected gland. Cable preparation and fixation (loose tube, The cable termination plate can be moved up or down and it IFC and breakout cable)
- Page 5 Cut the strength member on 75 mm. Fix the strength member FIST-GSS2 cable routing example 1 (shelf in bottom position). and cable. Cut the flex tube to length and install. FIST-GSS2 cable routing example 2 (shelf in top position).
- Page 6 Using two cable clamps on two cables. One clamp can be used on two cables.
- Page 7 Pigtails If pigtails have to leave a sealed rack, pigtail seals should be installed. Select a plate with the knock out ports. If needed the plates can be changed or moved by unscrewing the 4 screws. Open the knock out ports using a hammer and screwdriver and install the pigtail seal.
- Page 8 Tyco Electronics’ obligations shall only be as set forth in Tyco Electronics’ Standard Terms and Conditions Tel.: 32-16-351 011 of Sale for this product and in no case will Tyco Electronics be liable for any incidental, indirect or consequential damages arising out Fax: 32-16-351 697 of the sale, resale, use or misuse of the product.
Need help?
Do you have a question about the FIST-WR2 and is the answer not in the manual?
Questions and answers