Enable By Rfid Card - MG ChargeHub 7 Instruction Manual

B.2.2 Enable by RFID Card
a) Click "Software Setting" then find "Functions Enable".
b) For the Card Type, select "Start stop card". Then click" Submit".
c) Wait for 30 seconds, the system feedback will show "submit successfully".
d) Click "Refresh" to double check if the setting has been uploaded correctly.
e) Then, restart the charger (turn it off then turn it on).
f) The charger should be enabled by RFID Cards now.
To test the RFID Card: Firstly, connect the charger with your EV. Then tap the RFID Card on the RFID
sensor (directly above the MG logo on the front near the top). The charger LEDs should change to
indicate if the car is charging if it is plugged in.
MG MOTOR INSTRUCTION MANUAL
39